20 X Splashguard / Engine Under Tray plastic clips

Some of the models listed above use these clips for Undertrays and some use them for wheel arch linings.

VERY IMPORTANT - BEFORE YOU BUY - Make sure your old clips look identical to these, this is just one type of many - We dont know which one you need - you need to compare your old clips to the picture FIRST before you buy.

Dont just buy them and assume they will fit, a bit obvious really so do check first.

If you dont have an old clip to compare then phone a dealer and ask them if part number 90467-07201 is the one you require.

 

ALSO CHECK THE SIZES OF YOUR OLD CLIPS IT SHOULD BE AS FOLLOWS:

Push in Pin Head diameter 14mm

Main Head diameter 20mm

Stem length below head 10mm

To Fit 7mm Hole