This Electronic Ignition System is an easy to fit enhancement to ANY 6V POSITIVE EARTH classic car, bike  and older vehicle with conventional points based ignition system.  Positive earth systems will generally be found on pre and 1960's vehicles.

ADVANTAGES

• Easier starting
• Smoother running
• Higher energy plug spark from faster, cleaner "spark free break" at points.
• Better average fuel consumption due to car remaining in tune – Unit will pay for itself in fuel savings
• No burning or pitting of points, which cause ignition timing errors AND loss of power and economy
• No need to set or replace points every service – no more messing with timing lights!
• Points lasts MUCH longer, life limited only by the wear of the heel on the cam
• 50,000 mile  typical points life
•  Good for all rev ranges and cylinder combinations.

WHY  GO ELECTRONIC?

All modern vehicles benefit from electronic, high energy ignition systems. By fitting a Gammatronix unit, your classic vehicle can also enjoy these benefits. Retaining your original points and coil, you get  the improvements of a modern electronic ignition system, with minimal changes to your classic or older vehicle.  Our unit is an easy fitment, and is universal for all 6v POSITIVE  earth points and coil based  ignition systems. Its also compact at only approx approx 100mm x 50mm x 30mm in size. (If you require a negative earth version, please see our 'shop' listings for the "Powerdriver" variant).

IS IT RIGHT FOR MY VEHICLE?

It is if you can answer 'Yes' to the following questions :

• My car or bike has points based ignition with a coil
• My battery POSITIVE terminal is connected to the vehicle body
• My battery is 6v
• My ignition system is battery powered and not a magneto system. Magneto ignitions use a winding on the generator to power the spark. If you are in doubt, disconnect your battery and check if the engine still starts. If it does, it has a magneto ignition, and isn't suitable for this unit.

INSTALLATION

Simply mount the unit with the fitting kit supplied,  disconnect the original condenser, connect up the four wires (power, earth, points and coil) and thats it!

You can mount the unit directly to the coil or to any suitable point close by. No drilling required.

The fitting kit provided includes mounting straps, cable ties / tidies and full printed fitting instructions.

ADDITIONAL FEATURES

The unit has a handy red LED which can be used as a ‘timing light’ to indicate if the points are open or closed, and to confirm correct installation and operation.

Unit is British made.

The unit is brand new, and covered by a full 12 months guarantee.