Seller’s Note to clients :

For 15 years, Richmond Designs Inc , held a strong 100% rating with all positive feedback. I’m not begging for anything. I am only sending this note to clarify, why my feedback percentage is pitiful right now, and I credit this all to the United States Postal Service. They have ruined my business to a certain extent over the past nine months by losing packages and terribly slow deliveries.

Most people understood this and have worked with me, but unfortunately, there were two ignorant buyers who decided to blame the carriers negligence on my company !

I will have my 100 percent back soon

Please do not let this sway your decision on a purchase. I say this with complete honesty and confidence in our quality of fabric and excellent service.

Thank you for giving your valued time to read

Kenneth Lee Richmond II

Richmond Designs Inc

********************************************************

ZENITH WAVE DESIGN

The Wave design is reversible as shown in photos, and the repeat is approximately

1.5”x 1.0” 

Colors are Rust, Chocolate brown and Gold.The fabric is woven from Nylon yarn.This listing is for one 24” x 24” piece of Zenith Wave Design.

  ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~    Please be sure to click on See other items, just below our ebay name in the top right corner of the listing.Thank you,Richmond Designs Inc

 Thank you all,... for your support !!

Grill Cloth Installation Instructions 

First,...mist the cloth lightly with a water mist, spraying lightly , not heavy.  Then set your clean  iron on low to medium heat. In doing so for speaker cloth,..never hotter than you can touch without burning your hand.   Smooth the cloth if necessary,.. but do not  iron it completely dry. You want the cloth to be damp during the application process. This allows the cloth to shrink as it dries stretching any wrinkles that may be left..  Next make sure your pattern is aligned straight with the edge of your board  across the top and down the side before applying the spray adhesive.      Then,  using 3M Super 27 or 77 spray adhesive, apply it to the edge of the board and  all around the outer edge about a one inch wide band  on the face side.You do not want to spray glue all over the board.   Leave the inner field area of the board clean, free of any adhesive.This leaves the cloth free to stretch as it dries.     (You can also spray the glue on a piece of paper and use a brush for applying in tight places.)Let the glue dry for about 15 minutes. Do not spray adhesive anywhere on the cloth.             On a clean area of your work space, roll the cloth from the bottom up to the top, rolling your face side inward.  Start the application in one corner at the top checking your design to be straight across.  Then  roll it out top to bottom.  Make sure your first edge at the top is straight and secure. Then as you stretch the cloth gently, watch your pattern design , keeping it straight , so not to over stretch the design.   Tightening  slightly , top to bottom,... then side to side.  Once you have achieved the desired  position, fold the outer excess cloth down over the glued edge of your board.       Let the project sit about one hour, then after the cloth  has completely dried  you may finish the trimming the back edge.  Make sure to leave enough of the back edge of cloth to work with, in the event you may have to stretch an area a bit more.  

Thank you ,Richmond Designs Inc

Our  1930s

duplications are sold all over the world.

 Thank you for viewing,Richmond Designs Inc