• Fit Vehicles:
  •  
  • 2002-2003 Chevrolet Trailblazer 4.2L 2002-2003 Chevrolet Trailblazer EXT 4.2L 2002-2003 GMC Envoy 4.2L 2002-2003 GMC Envoy XL 4.2L 2003 Isuzu Ascender 4.2L 2002-2003 Oldsmobile Bravada 4.2L
  •  
  • Features:
  •  
    • Extensively Tested During Manufacture to Guarantee Quality and Reliability
    • Supplied With a Factory-Fitted Connector for Easy Installation
    • Precision manufactured with a sensing element incorporating premier technical ceramics
     
  •  
  • Where are my oxygen sensors located?
  •  
  •  
  • Diagnostic Trouble Codes (DTC)

    • O2 Oxygen 02 Sensor For 2002-03 Chevy Trailblazer 4.2L Upstream+Downstream X2

    Fit Vehicles:

     

    2002-2003 Chevrolet Trailblazer 4.2L
    2002-2003 Chevrolet Trailblazer EXT 4.2L
    2002-2003 GMC Envoy 4.2L
    2002-2003 GMC Envoy XL 4.2L
    2003 Isuzu Ascender 4.2L
    2002-2003 Oldsmobile Bravada 4.2L

     

    Features:

     

    • Extensively Tested During Manufacture to Guarantee Quality and Reliability

    • Supplied With a Factory-Fitted Connector for Easy Installation

    • Precision manufactured with a sensing element incorporating premier technical ceramics

     

     

    Where are my oxygen sensors located?

     

     

    Diagnostic Trouble Codes (DTC)


    When oxygen sensor failure occurs, a DTC is recorded in the Engine Control Unit (ECU) and a Malfunction Indicator Lamp (MIL) is illuminated on the dash, alerting the driver the vehicle has a problem.

     

    How to replace an oxygen sensor?

     

    1- Disconnect the battery.

    2- Locate the sensor connector by following its wires. Disconnect it.?

    3- Remove the sensor cable from its clips all along its way to the sensor.

    4- A specific 22mm socket with side cut out exists (see below). You can use a spanner instead. Hold it in one hand and give it a firm hit with the other hand. It will then unscrew very easily.

    5- Remove the sensor and fit the new one.

    6- Re-route the cable carefully and meticulously and fix it at every clip. Reconnect the connector.

    7- Reconnect the battery and wait 5 minutes before starting the engine. 

     

                   

                   

            

     

     

    Please take a video clip of the voltmeter and contact us if our sensor:

     

    Goes above range between 0.1 and 0.9 volt
    Remains below 0.5 volts
    Stays fixed at a particular voltage
    You're free to choose replacement or refund if our sensor fails to work, in this case.


    Item Specifics
    Type Oxygen Sensor
    Manufacturer Part Number HD831RE849G1
    Brand Hdautoworld
    Number of Pieces 2
    Fitment Type Direct Replacement
    Interchange Part Number O2 Oxygen Sensor
    Manufacturer Warranty 1 Year
    Custom Bundle Yes
    Modified Item No
    Position Upstream, Downstream
    Universal Or Specific Fit Specific
    Attachment Method Screw-On
    Thread Size M18
    Terminal Type Blade
    Thread Diameter 0.708 In.
    Heated Yes
    Hex Size 7/8 in
    Number of Wires 4, 4
    Wires 4, 4
    Housing Material Metal
    Automotive Color / Finish Steel
    Technology Narrow-band
    Placement on Vehicle Before After Catalytic Converter
    Location Front, Rear
    Output Signal Range (V) 0.2 To 0.8 Volt
    Length 0 In.
    Bundle Description Include 2 Piece Oxygen Sensor
    Length 0 In.
    Bundle Description Include 2 Piece Oxygen Sensor
    Type Sensor
    Features Direct Fit

    Payment

    1. We accept multiple payment methods. 

    2. Payment must be made within 4 days of auction closing. 

    3. Total amount due includes the final auction price plus S&H(Shipping and Handling). 

    Shipping

    1.Our shipping rates include the cost of shipping,handling,packaging and related manpower costs.
    2.All item will be shipped by USPS&Fedex within 1 business days,It takes approximately 3-8 workdays.
    3.We ship to US ONLY.
    4.All items will be shipped to buy's paypal address.Please check your paypal address is right.
    5.We are not responsible for wrong or undeliverable address.We reserve the right to charge the shipping fee again for returned items due to wrong address.

    Returns

    We stand behind every product we sell.
    All of our brand new items come with a 30-Days money-back guarantee.

    Contact Us

    If there have any question pls contact us first(send us ebay message),we will try our best to help!

    Feedback

    1.Once we have received your order, a feedback will be automatically sent to you.

    2.Please let us to know if you have not received our feedback, we will give feedback manually.

    3.If there's any question or problem before leaving feedback, feel free to contact us please, we will try our best to solve it.

    If you feel that we deserve a neutral or negative feedback, please, CONTACT US before leaving any feedback, give us a chance to make things right and leave your a good impression! 

    Shop Category
     Store Home
     Hydraulic Lifter&Roller Lifter
     Timing Solenoid Valve
     LED headlight Assembly
     Running Board Motor
     Fuel Pump
     Window Switch
     Water Pump
     Engine Mount
     Regulator Rectifier
     Cylinder Head Gasket Sets
     Exhaust System Parts
     Alternator
     PTO Clutch
     intake Manifold
     Intake Hose
     winch
     AC Compressor
     Timing Belt Kit
     Cold air intake kit
     Dash cover
     Clinder piston gasket kit
     Window Regulator
     car tool
     Turbocharger
     Tire Pressure Sensor
     Ignition coil
     Drive shaft
     CV Axle Assemblies
     Cv Axle
     Lift Support
     Bumper
     Shocks, Struts & Assemblies
     Car Truck Mirror Assemblies
     TPMS Tire Pressure Sensor
     PVC Fabric RV Awning Fabric
     Throttle Body
     Golf Cart Cushion Set
     Spark Plugs
     O2 Oxygen Sensor
     Wheelchair Ramp
     Roof Rack Cross Bar
     ATV Rear Wheel Axle
     Brakes & Brake Part
     Leaf Spring Shackle Kit
     Air Dryer
     Brake Booster
     Mud Flaps
     Window Weatherstrip Seal
     Catalytic Converter
     Other
    Hot Item
    Picture

    content_src_url

    New List Item
    Help & Info
    Payment Policy
    Shipping Policy
    Return Policy
    FAQ
    About Us
    O2 Oxygen 02 Sensor For 2002-03 Chevy Trailblazer 4.2L Upstream+Downstream X2

    Fit Vehicles:

     

    2002-2003 Chevrolet Trailblazer 4.2L
    2002-2003 Chevrolet Trailblazer EXT 4.2L
    2002-2003 GMC Envoy 4.2L
    2002-2003 GMC Envoy XL 4.2L
    2003 Isuzu Ascender 4.2L
    2002-2003 Oldsmobile Bravada 4.2L

     

    Features:

     

    • Extensively Tested During Manufacture to Guarantee Quality and Reliability

    • Supplied With a Factory-Fitted Connector for Easy Installation

    • Precision manufactured with a sensing element incorporating premier technical ceramics

     

     

    Where are my oxygen sensors located?

     

     

    Diagnostic Trouble Codes (DTC)


    When oxygen sensor failure occurs, a DTC is recorded in the Engine Control Unit (ECU) and a Malfunction Indicator Lamp (MIL) is illuminated on the dash, alerting the driver the vehicle has a problem.

     

    How to replace an oxygen sensor?

     

    1- Disconnect the battery.

    2- Locate the sensor connector by following its wires. Disconnect it.?

    3- Remove the sensor cable from its clips all along its way to the sensor.

    4- A specific 22mm socket with side cut out exists (see below). You can use a spanner instead. Hold it in one hand and give it a firm hit with the other hand. It will then unscrew very easily.

    5- Remove the sensor and fit the new one.

    6- Re-route the cable carefully and meticulously and fix it at every clip. Reconnect the connector.

    7- Reconnect the battery and wait 5 minutes before starting the engine. 

     

                   

                   

            

     

     

    Please take a video clip of the voltmeter and contact us if our sensor:

     

    Goes above range between 0.1 and 0.9 volt
    Remains below 0.5 volts
    Stays fixed at a particular voltage
    You're free to choose replacement or refund if our sensor fails to work, in this case.

    Item Specifics
    Type :Oxygen Sensor
    Manufacturer Part Number :HD831RE849G1
    Brand :Hdautoworld
    Number of Pieces :2
    Fitment Type :Direct Replacement
    Interchange Part Number :O2 Oxygen Sensor
    Manufacturer Warranty :1 Year
    Custom Bundle :Yes
    Modified Item :No
    Position :Upstream, Downstream
    Universal Or Specific Fit :Specific
    Attachment Method :Screw-On
    Thread Size :M18
    Terminal Type :Blade
    Thread Diameter :0.708 In.
    Heated :Yes
    Hex Size :7/8 in
    Number of Wires :4, 4
    Wires :4, 4
    Housing Material :Metal
    Automotive Color / Finish :Steel
    Technology :Narrow-band
    Placement on Vehicle :Before After Catalytic Converter
    Location :Front, Rear
    Output Signal Range (V) :0.2 To 0.8 Volt
    Length :0 In.
    Bundle Description :Include 2 Piece Oxygen Sensor
    Length :0 In.
    Bundle Description :Include 2 Piece Oxygen Sensor
    Type :Sensor
    Features :Direct Fit


    1. We accept multiple payment methods. 

    2. Payment must be made within 4 days of auction closing. 

    3. Total amount due includes the final auction price plus S&H(Shipping and Handling). 

    1.Our shipping rates include the cost of shipping,handling,packaging and related manpower costs.
    2.All item will be shipped by USPS&Fedex within 1 business days,It takes approximately 3-8 workdays.
    3.We ship to US ONLY.
    4.All items will be shipped to buy's paypal address.Please check your paypal address is right.
    5.We are not responsible for wrong or undeliverable address.We reserve the right to charge the shipping fee again for returned items due to wrong address.

    We stand behind every product we sell.
    All of our brand new items come with a 30-Days money-back guarantee.

    If there have any question pls contact us first(send us ebay message),we will try our best to help!

    1.Once we have received your order, a feedback will be automatically sent to you.

    2.Please let us to know if you have not received our feedback, we will give feedback manually.

    3.If there's any question or problem before leaving feedback, feel free to contact us please, we will try our best to solve it.

    If you feel that we deserve a neutral or negative feedback, please, CONTACT US before leaving any feedback, give us a chance to make things right and leave your a good impression! 


    All rights reserved.