The Zamp Z-20 Series shields are expertly created to provide an optimal fit for all Zamp RZ Series helmets, offering both enhanced performance and protection. Designed with precision, these high-quality shields are made from durable 3mm thick material, ensuring superior impact resistance and durability during high-speed racing conditions. The shields also feature strategically placed tear-off posts, allowing for quick and easy removal of tear-offs during races to maintain clear visibility, even in the toughest conditions.

One of the standout features of the Zamp Z-20 shields is the anti-fog coating, which significantly reduces fogging, ensuring that drivers can maintain an unobstructed view, no matter how intense the race or extreme the weather conditions. This coating enhances safety by providing reliable clarity throughout the event, especially when racing in humid or high-moisture environments.

In addition to the RZ Series helmets, these shields are also compatible with the V2 Super-vent helmet, making them a versatile and practical choice for racers who want to upgrade or replace their visors. Whether you are competing in go-karting, motorsports, or any high-performance racing event, the Zamp Z-20 shields deliver both exceptional visibility and protective features, allowing you to focus on the race without worrying about helmet or visor issues.

Zamp Z-20 Shield Replacement:

NOTE: It is important to NOT USE power tools or over tighten screws when changing shields.

• Step 1 Lay a towel on a flat surface and set the helmet on it.

• Step 2 Remove the shield pivot tensioners on each side. This is the smaller screw on the sides of the shield.

• Step 3 Remove shield pivot screws on each side. This is the larger screw on the side of the shield. For best results, we suggest using a quarter to loosen/tighten this.

• Step 4 Remove shield. We suggest using a cloth towel to wipe down the rubber seal as well as where the shield mounts to the helmet for best results.

• Step 5 Place shield on helmet. There are two white washers that go between shield and helmet, make sure they are in place before re-installing shield.

• Step 6 Hand thread in the shield pivots (larger screw) to hold the shield in place. Once hand threaded, use a coin and tighten until they are snug with helmet shell. Do not over tighten.

• Step 7 Hand thread in the shield pivot tensioners, then tighten to desired tension for shield movement.