This is a replacement nose for the small Snowman from TPI with a birdhouse.
This is a 3d printed design created and printed by our family. The 3rd picture shows an original nose beside the 3d printed design. You will only receive one 3d printed carrot nose version per purchase. The original is shown for comparison only. The original was very thin & flimsy and would break at the knob. This has been upgraded to a more solid design which is stronger. The blow mold is shown for reference only.
The video shows how easy this is to install, and how well it fits.
We size as accurately as possible with pin type push thru parts making several sets until we are happy with the results, but your blow mold may be slightly smaller or larger due to difference in wear. You may need to add a small amount of glue to hold in place or sand or drill a tiny bit to make fit if too tight (do not force).