FOR PROJECTS OMATCH WITH CHAINSAW FOR BRANCHES PRUNING POLE SAW N THE GROUND

8 Inch Chainsaw Chain Parameters

Chisel TypeSemi-chisel
Guide Bar Length8 inch
Drive Links33
Pitch3/8" low profile
Gauge.050"
Sharpenning files5/32"
MaterialGerman steel
BrandUPFOREST

This saw chain met the kickback performance requirement of ANSI B175.1-2012 when tested according to the provisions of ANSI B175.1- 2012. Low-kickback saw chain meets the kickback performance requirement of CSA Standard Z62.3.

S33 chainsaw chain compatible with the following saw

  • Compatible with Chicago 68862 Pole Saw
  • Compatible with Harbor Freight Portland pole saw 68862 63190 62896
  • Compatible with Remington # 713-05073, RM4050 RM4050B pole saw
  • Compatible with Craftsman 151.74326
  • Compatible with Poulan PPB40PS, RM4050, RM4050B Pole Saw
  • Compatible with Earth-wise CCS30008 18Volt, CPS40108, CVP41810, CVPS41008, LPS40208, LPS4210, NVPS42108, PS40008, PS43008
  • Compatible with Greenworks 1400102 24V Li-ION Pole Saw, 20192 6.5 Amp Pole Saw, 20302 40V Polesaw, 20352 24V Li-ION Pole Saw, 20672 40V Polesaw, 20V Li-ION Pole Saw 20612, 6.5 Amp Pole Saw, PSPH40B00
  • Compatible with 506891 Kobalt 40V Polesaw, KPS 80-06 Kobalt 40V Polesaw, KSP 80-07 Kobalt 40V Polesaw
  • Compatible with Fun Joe SWJ800E, SWJ800E Pole Saw, SWJ802E Pole Saw, SWJ806E, iON8PS Pole Saw

Chainsaw Chain

How-to: Bar and Chain Fit-Up

*You can find the parameter on your old saw chain package or the stamp on your guide bar. If you still cannot find them, you must measure the values manually.

How to measure?

  • Bar length: Determine guide bar length by measuring from the base of the guide bar to the tip of the bar.
  • Chain Gauge: Chain gauge is the thickness of each drive link. Find your gauge by measuring the section of the drive link inside the groove of the guide bar.
  • Chain Pitch: Pitch is the distance between drive links. Measure pitch by counting three links in a row and dividing by two.
  • Drive Links: Count each drive link to know the total number of drive links on your saw chain.

Raw Materials

Raw Materials

  • The raw materials of the main components of the UPFOREST sawchain are directly imported from Germany. This is different from other manufacturers in that they only use imported raw materials in some of the parts, or even do not use imported raw materials.
  • The raw materials of cutters, drive links, tie straps are called 68CrNiMo, rivet is called GCr15, which is the same raw material used by Stilh.
  • Each batch of raw materials has a product quality inspection report, and passes through our quality inspection department to ensure that our saw chain has the best performance.