Fits:  

• 1997-2014 Ford E150 Van Front with Air Conditioning
• 1997-2014 Ford E250 Van Blower Motor Resistor
• 1997-2005 Ford E350 Van Front with Air Conditioning
• 1999-2017 Ford E350 Van Super Duty Front with Air Conditioning
• 1997-2017 Ford E450 Van Front with Air Conditioning
• 2000-2005 Ford Excursion Front with Manual Air Conditioning
• 1999-2007 Ford F250 Super Duty Truck Blower Motor Resistor 2 Mounting Holes
• 1999-2007 Ford F350 Super Duty Truck Blower Motor Resistor 2 Mounting Holes
• 1999-2007 Ford F450 Truck 2 Mounting Holes
• 1999-2007 Ford F550 Truck 2 Mounting Holes
• 2000-2010 Ford F650 Truck Blower Motor Resistor 2 Mounting Holes
• 2000-2010 Ford F750 Truck Blower Motor Resistor 2 Mounting Holes

What is a Blower Resistor?

Blower resistors are resistors which are used to control the fan speed of automotive blowers. The fan speed can be changed either by switching the blower resistor resistance mechanically using a rotating lever, or electronically by the air conditioning system. The change in resistance then limits the current through the motor, which dictates the speed at which the blower fan operates. A failed blower motor resistor can cause your car's fan to stop working completely.

Construction：

Blower resistors, being a mechanical component, are prone to wear and are the most common point of failure in a car’s heating system.

How to diagnose a blower fan motor?

• Check the fuse for power on both ends using a multimeter. If there is power on one end of the blower fan fuse but not the other, then the fuse needs to be replaced.
• Check the fan relay. Such relays can be tested by placing a finger on them and switching the fan’s control on and off. Clicking from the relay is an indication that the relay is almost certainly working correctly.
• Check the fan itself for power presence by turning on the fan control and checking the fan itself with your multimeter. If there is no power present at the fan, suspect a wiring fault. If power is present on the fan’s terminals and the fan is not working, the blower fan is defective.
• Once the resistor is located and detached, it is often possible to say whether the resistor has burned out or not judging by the physical appearance only.

• If the appearance is normal, it is necessary to measure the resistance across each individual resistor. If any of these resistances show an open circuit (infinite resistance), then the blower resistor needs to be replaced.

   

Specifics:

• Built to strict quality control standards
• 100% brand new, in-the-box auto parts.
• precision-engineered to match the fit
• Drop in fit for easy installation
• 1 year Warranty

How to replace a Blower Control Module?

Materials Needed

• New blower motor resistor.
• Wire stripper.
• Electrical tape.
• Dielectric grease.
• Screwdriver.
• Wire cutter.

Do it:

Step 1: Locate the Blower Motor Resistor

Step 2: Take out the Blower Motor Resistor

Step 3: Disconnect the Wires

Step 4: Install the New Blower Resistor

Step 5: Verify the operation of replacement relay.