Fab & Fix Sensei Tilt & Turn Window Handle

Fab & Fix Sensei Tilt and Turn locking window handle with a high-quality finish, stylish lines and coordinated screw cover plates. This handle with its classical design also adds a contemporary twist which gives an alternative look to the Hoppe.

The Sensei has a lovely long handle with a 51mm window clearance and a heavy-duty sprung latching wedge which gives a very positive click on closing. The spindle is 45mm (White and Chrome) and 30mm Gold in length and can be easily trimmed with a junior hacksaw. The handle locks in the closed position, locks at 0 degrees, firm hold when 90 or 180 degrees.

All in all, a lovely handle in a choice of finishes to match your home.

Features:

Comes complete with a security key
10mm diameter fixing lugs
Co-ordinated metal cover caps to conceal screw fixings (supplied)
Easy to fit by removing/reinstalling 2 x screws
The handle locks in the closed position, locks at 0 degrees, firm hold when 90 or 180 degrees

What's in the pack?

1 x "Fab & Fix" Tilt & Turn Handle

1 x Key

2 x Screws

2 x Screw cover plates

Dimensions:

Screw hole Centres: 43mm
Spindle Width: 7mm
Spindle Length: 45mm (White and Chrome) 30mm Gold

Please see technical diagram in gallery.

What do I need to check before ordering a handle?

Handle Screw Hole Fixing Centres:

Fortunately most tilt and turn handles are made to industry standards with 43mm between the screw hole centres, therefore it really doesn't matter if you choose a style that's different to your existing handle, as long as the handle centres measure 43mm these handles will fit.

Spindle Length:

The spindle is 45mm (White and Chrome) and 30mm Goldin length and is measured from the base of the handle to the end of the spindle. (Please see measuring diagram).

How to fit a Tilt and Turn handle:

Most Tilt and Turn handles can be fitted without too much difficulty. The fixing screws will be obscured with either cover caps or, in most cases, a cover plate.
First turn the handle horizontally 90° then remove cover caps with a sharp object or slightly lift and turn the cover plate to reveal the screw fixing positions.
With a screwdriver unfasten the screws to remove the handle. Measure the old handle spindle against your new handle and using a hacksaw cut the spindle of your new handle to the same length.
Keeping the new handle in the same position as the old one (90° Horizontal) simply refit the new handle and tighten the screws, returning the handle downwards into the locked position once more.