1.It can be connected with a speed display board to display the speed; it can also be connected to a computer to set drive parameters.
2.Current and speed double closed-loop design, large torque at low speed, stable operation
3.High torque and high speed output, the highest speed reaches 10000rpm /min (depending on motor speed)
4.With pulse speed output, you can observe the motor speed at any time
5.Speed regulation mode: 0-5V analog and 100Hz-100 KHZ PWM
Speed regulation
6.With EN (enable), DIR (direction) and other signal input terminals
7.Can output speed measurement pulse, (photoelectric isolation, gate output)
Electrical performance
- Power supply: AC80V~ 220V AC power supply, the capacity is selected according to the motor power
- Output maximum current: no more than 10A (depending on the motor and rated load)
- Input maximum power: maximum 2000W
- Adapted motor: Adapted to motor with output power ≤1500W
- Insulation resistance:> 500MΩ at normal temperature
- Insulation strength: 0.5KV for 1 minute at normal temperature and pressure
Applicable environmental parameters
Cooling method: natural air cooling (forced air cooling is recommended)
Use occasions: try to avoid dust, oil and corrosive gas
Temperature: 0 ° C ~ + 50 °C
Humidity: <80% RH, no condensation, no frost
Vibration: 4.9m / s + Max
Storage temperature: -20 °C ~ + 65 °C
Dimensions: 198 * 103 * 86mm
Weight: about 1.2kg
This product can realize the following functions: (Standard factory default setting is square wave Hall open loop mode)
1. Square Wave has Hall Speed Open Loop Operation
2. Square wave has Hall speed closed loop operation
3. Square wave without Hall speed open loop operation
4. Square wave without Hall speed closed loop operation
5. Constant torque open-loop mode operation (Long-term overload operation is strictly prohibited)
6. Constant Torque Closed-Loop Mode Operation (Long-term overload operation is prohibited)
The above functions can be set according to the PC software or handheld debugger provided by our company.
