Devilbiss 905240 PRO-102-TE10-K, TE10 Air Cap
Description
Devilbiss Replacement Air Cap TE10 suitable for 2018 on GTi Pro and all GTi Pro Lite Models
Genuine Devilbiss product
Which air cap is for me ?
Air Cap TE10 – basecoat & all rounder
Application: Standard water and solvent base basecoats, Air dry and MS clearcoats
Performance Data: Spray Pattern: 290-310 mm (11-12″)
Air Flow (@ 2bar): 280 lpm (9.9 cfm)
Comments: Slower than TE20
Air Cap TE20 – clearcoat with faster flow
Application: Clearcoats (especially HS and UHS clearcoats) Recommended for polyurethane clear coats (in combination with 1.3mm nozzle)
Performance: Spray Pattern: 285-300 mm (11-12″)
Air Flow (@ 2bar): 350 lpm (12.4 cfm)
Comments: Faster than TE10
In connection with 1.3mm nozzle widely recommended for 2K gloss / clearcoat
Air Cap HV25 – compliant atomizing technology meets HVLP
Application: Higher solid clearcoats, solvent and waterborne basecoats
Performance: Spray Pattern: 305-320mm (12.2-12.9″)
Air Flow (@2bar): 350 lpm (12.4 cfm)
Air Cap HV30 – maximum transfer efficiency
Application: water base basecoat and clear coat
Performance: Spray Pattern: 300-325mm (12-13″)
Air Flow (@2bar): 460 lpm (16.3 cfm)
Air Cap T110 – clear coats with higher solids
Application: clearcoats (with higher solids)
Performance: Spray Pattern: 260-290 mm (10-11″)
Air Flow (@2bar): 265 lpm (9.4 cfm)
Comments: Glass finishing
The most “forgiving” air cap
What are the recommended air pressures for the air caps?
The air pressure depends on different factors, e.g. the fluid to be sprayed or whether the fluid control is full open or not. A good starting point are following pressure settings:
HV25/30 Air cap/s: 1.5 – 1.75 bar (22-25 PSI)
TE10/20, T110 Air cap/s: 1.5 – 2 bar (22-29 PSI)