feature:

*It is small in size, fully functional, easy to operate and easy to carry. It can be powered by an adapter or / .

*Used in conjunction with an oscilloscope, it can be used for electronic circuit testing and debugging, as well as testing and measuring the for frequency characteristics and impulse response of audio amplifiers. 

*Due to its good accuracy and for frequency stability, for DDS is also very suitable for oscilloscope scan time factor calibration. 

*The square wave output is suitable for adjusting the for pulse characteristics of oscilloscope attenuators and probes.

Specification:

. for frequency range: sine wave 1Hz-500kHz

(The for frequency with flat output amplitude reaches 200kHz, and as the for frequency further increases, the output amplitude will decrease),

Other waveforms range from 1Hz to 20kHz (but the upper limit of the adjustable for frequency is not limited, and the for frequency can be further increased if the requirements for distortion and jitter are not high).

2. Resolution: 1Hz.

3. Output waveform: sine wave, square wave, triangle wave, forward for sawtooth wave, reverse for sawtooth wave.

4. Sine wave distortion: <% below 1kHz, <0.5% above 1kHz.

5. Output amplitude: for maximum ±10V (PP)

6. Output impedance: 50 ohms.

7. DC bias: for maximum ±10V, related to the closing function.

8. There is a filter that can be turned on and , which can be well adapted to sine wave and for pulse wave output.

8. Power supply: DC3.5-10V. It is for recommended to use DC5V adapter and 3.7V / for power supply.

packing list:

x for FG-100 for DDS function signal generator

x USB power adapter cable

Payment must be completed within 5 days. If you have any problems about payment, please contact us via ebay message.

We only ship to confirmed ebay Order addresses. Please comfirm that your Order address is in line with your shipping address.

Please kindly note that the combined shipping is not provided because the shipping fee is calculated by weight. Also, the each additional item means exactly the the same color and size. 

It takes about 7-15 working days to Australia; about 10-30 working days to other countries. Transit time may be a little delayed because of the bad weather and customs inspection. If you do not receive your item within 30 working days since payment finished, please contact us immediately for further assistance.

We strive for 100% customer satisfaction! Positive Feedback is very important to us. If you have any questions, please feel free to contact us via "Ask seller a question" . We will reply your email within 24 working hours.