VESSEL electric driver Ball Grip Plus 220USB-P1 3 Speed & Torque USB Charge
Description
◆It is equipped with number of revolutions, torque three phases reshuffling mode.
◆I improved strength by reinforcement gear & front housing adoption.
◆We adopt USB type C connector not to be at a loss at the time of charge.
◆It is with fall prevention cord mounting hole to prevent fall accident.
◆The high brightness LED light deployment that turns on after stop for approximately five seconds.
◆Bit chuck that can use double-headed and single-headed bits.
◆ For electronic terminal block work, distribution board terminal work, light weight screw and long screw tightening.
■Specifications■
Rated Voltage: DC 3.6V
Rated capacity: 800mAh
Applicable bit: Opposite side 6.35mm
No-load speed...
Low: 280min-1
Medium: 340min-1
High: 400min-1
Maximum tightening torque (electric)...
Low: 1.2N・m
Medium: 1.6N・m
Height: 2.0N・m
Maximum endurance torque (approx.): 12 N m (manual)
Shaft length: 100mm
Opposite side: HEX 6.35mm
Total length: 147mm
Handle diameter: φ45mm
Weight (about): 170g
Environmental temperature range (about)...
When charging: 0℃ to +40℃
During operation and storage: 0°C to +45°C
Charging port: USB Type-C
Charging time (approx.): 60 minutes
Charging times (approx.): 500 times
Input voltage (maximum): DC 5V
Input current: 1A
Material: Body/PA6GF15 + Elastomer, Bit/Special Alloy Steel
Set contents: 1 main unit, 1 bit (+2 x 100 mm), 1 charging cable, instruction manual
If the desired quantity is greater than the stock of the page, please message.
We will prepare your desired quantity.
◆I improved strength by reinforcement gear & front housing adoption.
◆We adopt USB type C connector not to be at a loss at the time of charge.
◆It is with fall prevention cord mounting hole to prevent fall accident.
◆The high brightness LED light deployment that turns on after stop for approximately five seconds.
◆Bit chuck that can use double-headed and single-headed bits.
◆ For electronic terminal block work, distribution board terminal work, light weight screw and long screw tightening.
■Specifications■
Rated Voltage: DC 3.6V
Rated capacity: 800mAh
Applicable bit: Opposite side 6.35mm
No-load speed...
Low: 280min-1
Medium: 340min-1
High: 400min-1
Maximum tightening torque (electric)...
Low: 1.2N・m
Medium: 1.6N・m
Height: 2.0N・m
Maximum endurance torque (approx.): 12 N m (manual)
Shaft length: 100mm
Opposite side: HEX 6.35mm
Total length: 147mm
Handle diameter: φ45mm
Weight (about): 170g
Environmental temperature range (about)...
When charging: 0℃ to +40℃
During operation and storage: 0°C to +45°C
Charging port: USB Type-C
Charging time (approx.): 60 minutes
Charging times (approx.): 500 times
Input voltage (maximum): DC 5V
Input current: 1A
Material: Body/PA6GF15 + Elastomer, Bit/Special Alloy Steel
Set contents: 1 main unit, 1 bit (+2 x 100 mm), 1 charging cable, instruction manual
If the desired quantity is greater than the stock of the page, please message.
We will prepare your desired quantity.
