Ikea kallax shelf connector

3D printed clamps to stop your stacked shelf unit falling over without drilling holes in your walls!

I also have clips that fit from the rear only but will screw into the original kallax units holes. See my other listings. Whatever you need, I can make for you.

PLEASE NOTE:- There are 2 clips in each photo to give you an idea of surface finish at every angle. The price is for 1 only.

Common sense needs to be used here as these and nothing will ever be as secure as screwing your unit to the wall! These are very strong and sturdy but I still wouldn't recommend climbing on your shelf unit after securing with these. They can however be screwed to your shelves from the top and bottom.

These will fit over 2 x 37mm wide Kallax unit walls. Make sure the walls of your units are this size (74mm when sandwiched together) before purchase.

Please ensure the correct size before ordering. If your size is different, LET ME KNOW!

If you need any other size, let me know. All I need is your measurement.

I will not accept any liability for accidents caused by the use of these clips. They made my life easier so I thought I'd share.

If you need in any colour not listed, please get in touch.

Please note:

These are not an official safety device, they are to stop your top unit toppling over!

Remove your felt feet before use!