PLEASE NOTE — TWO UNITS PICTURED, ONE UNIT PER SALE.
We have two of these nodes available, and we have photographed both of them so you can see exactly what we have rather than a single representative picture. This listing is for one node.
The two units are in equivalent condition, both were pulled from the same rack, both are on the same software version, and both have been powered up and confirmed working. We are not able to reserve a particular serial number, so we will send whichever one is next to hand — but whichever arrives, it will be one of the two shown here, in the condition shown.
BOTH UNITS TESTED AND WORKING. Each was powered up and booted before listing — see the photos. Unit one reads Version 3.1.2.5 · IP 192.168.0.26; unit two reads Version 3.1.2.5 · IP 192.168.0.32. Both show MANET 2 · Session 2 with ports A–H configured as outputs and the POWER LED lit. The rear panel requires software 2.9.x or higher — both units are on 3.1.2.5, well past that.
Everything below is printed on the units themselves and visible in the photos:
Important — these are the standard nodes, NOT the "onPC" variant. The front panels read "8PORT NODE" with no onPC designation. If you are buying this specifically to unlock parameter output on grandMA2 onPC software, this is not the unit that does that — you want an 8Port Node onPC. Please be sure of which one you need before purchasing.
Included: one node only. No power cable is included — note these use a Neutrik powerCON input, not a standard IEC cord, so budget for the correct cable. No DMX cables, ethernet cable or documentation included.
Condition: used, in good working order, with cosmetic wear consistent with rack-mounted service — light scuffing on the chassis and paper labels applied to the top and rear (port numbers on one, universe numbers on the other), which peel off. Please review all photos.
Ships from Madison, North Carolina.