- Condition: 100% new
- Color: White
- Material: Metal & Plastic
- Voltage: 5V
- Current: 15mA
- Maximum(Peak) Current: 300mA
- Number of Ports: 3 Pin & 2 pin
- Item included:
1 x 3DTouch Auto Bed Leveling Sensor
1 x 1M Wiring Harness
1 x 200mm Wiring Cables
1 set M3 Nuts, Bolts and Washers
- Compatible With: fit for CR-10 Ender-3 Creality 3D Printer
-
Only the above package content, other products are not included.
- Note:
Color may vary slightly due to the color setting of each individual monitor.
Feature:
1) 100% brand new and high quality.
2) The 3D Touch is an affordable alternative to the original probe. It is a high precision, touch-based bed leveling sensor intended for use with 3D Printers. It consists of an RC Servo and Micro Switch that maps the build surface, capable of achieving a perfect first layer every time.
3) The 3DTouch uses a push pin design and is compatible with almost all surface types, including glass, metal, wood and other popular build platforms.
4) Using the Hall Effect, it probes a defined number of points on the bed, then adjusts the Z-axis height during printing to compensate for variations in the surface. This makes it an ideal solution for warped or deformed build plates that are not perfectly flat.
5) 3Pin: Brown(- , GND) Red(+5V) Orange(control signal) & 2Pin: Black(-, GND) White(Zmin)
