-
Category - Coilover/Shock Absorber
- Turbochargers
- Brake Calipers
- Injector Harness
- Valve Parts
- Ignition Coilpacks
- Oil Line
- Sunshade
- Connectingrods
- Air Suspension
- Steeringparts
- Carburetors
- Exhaust Manifold
- Oxygen Sensor
- Air Bag
- Camber Plates
- Control arm
- Engine Gaskets
- Oil Pump
- Hydraulic Roller Lifters
- Smog Air Pumps
- Turbo Cartridges
- oilcooler
- Cylinderpistonkit
- Transmission
- Engine Motor
- Air Fuel Ratio Sensor
- Starter Motor
- Air Intake Hose
- Timing Tool Kit
- fuelpump
- Windshield Wiper Motor
- Glass Hinge
- Other
Parautoecommerce
Rear Brake Rotors & Ceramic Pads Set for Acura MDX 2007-2013 Honda Pilot 2009-14
Rear Brake Rotors & Ceramic Pads Set for Acura MDX 2007-2013 Honda Pilot 2009-14

Notice: Please double-check the OE number before purchase. You can verify it by providing the last 8 digits of your VIN to any local authorized dealer.
Application:
For Acura MDX 2007-2013 All Models
For Acura ZDX 2010-2013 All Models
For Honda Odyssey 2011-2017 All Models
For Honda Pilot 2009-2014 All Models
OE/Part number:
Rear Brake Disc:31469,S31469,S-31469
Rear Brake Pads:1281,P-1281,P1281,D1281
Specification:
Condition: New
Placement on Vehicle: Rear, Left, Right
Instruction Included:Yes
Produced under an IATF 16949 quality management system
✔ Tested in accordance with relevant performance and durability requirements
✔ Strict quality inspection for dimensional accuracy and material consistency
Product size:
- Brake Rotors
| Rear Dirver & Passenger Side | |
| Material | G3000 |
| Solid Or Vented Type Rotor | Solid |
| Rust Resistant Coating | Anti-rust oil treatment |
| Directional or Non-Directional Brake Surface |
Directional |
| ABS Tone Ring Included | No |
| Bearings Included | No |
| Mounting Bolt Hole Quantity | 5+2+2+1 |
| Mounting Bolt Hole Circle Diameter(mm) | 120 |
| Outside Diameter(mm) | 333.5mm / 13.15 inch |
| Overall Height(mm) | 63.7 |
| Nominal Thickness(mm) | 11 |
- Brake Pads
| Rear Dirver & Passenger Side | |
| Fitment | Direct Replacement |
| Backing Material | Steel |
| Pad Material | NAO Ceramic |
| Pad Shims Included | Yes |
| Mounting Hardware Included | Yes |
| Mounting bolt | No |
| Lubricant Included | Yes |
| Pad Wear Sensor Included | Yes |
| Pad Wear Sensor Type | Mechanical Sear Senso |
| Inner Pad Width(mm) | 113.36 (±0.3) |
| Inner Pad Height(mm) | 48.5 (±0.3) |
| Inner Pad Thickness(mm) | 14.8 (-0.5) |
| Outer Pad Width(mm) | 113.36 (±0.3) |
| Outer Pad Height(mm) | 48.5 (±0.3) |
| Outer Pad Thickness(mm) | 14.8 (-0.5) |
Note on Initial Brake Noise
- Common Causes:
① New pads and rotors not fully bedded, causing uneven contact.
② Before anti-rust coating on rotors wearing off, may cause slight hissing.
③ Thin surface rust forms on rotors overnight in humid conditions, resulting in a squeak during initial braking.
- Resolution:
Noise will naturally disappear after 200–500 miles of normal driving. Avoid hard braking during this period.
Package included:
2x Rear Drilled and Slotted Brake Rotors
4x Rear Brake Pads w/Hardware
Features:
● Heat dissipation cuts thermal fade for stable braking
● Lightweight build enhances handling & responsiveness
● Reduce noise for quiet & smooth braking
● Shorter stopping distance in emergencies
Notice:
● New installed, if noise, it takes hundreds of miles to run in.
● If shaking, usually not installed correctly, try to instal again
● Please confirm your vehicle condition and OE number before placing an order!
● Please note that this is an after-sales part, not an original part.
● We suggest that you seek professional installation to avoid unnecessary trouble.
● .
