1. Power supply voltage: 9V ~ 24V

2. Signal input voltage range: 4～24V

3. Signal input frequency range: 50Hz～10KHz

4. Range of signal input duty ratio: 0～100%

5. Output voltage: 0.00V ～ 5.00V/0.00V ～ 10.00V

6. Input mode: S1 pad on the circuit board: the default is open circuit, which has not been used yet.

7. Output mode: S2 pad on the circuit board: open circuit (output 0.00V ~ 5.00V); short circuit (output 0.00V ~ 10.00V), the default is open circuit.

8. Application range: remote data acquisition and control equipment;

9. Size: (length) 26mm * (width) 23mm * (height) 10mm

10. Module interface:

24V: Positive power supply interface (9V ~ 24V).

G: Power ground interface.

IN: Signal input positive port.

G: Signal input negative port.

OUT: Signal output interface (0.00V ～ 5.00V/0.00V ～ 10.00V).

G: Power ground interface.

Note: When the output is 0.00V to 10.00V, the power supply voltage must be 15V.

Output (0.00V ～ 5.00V) Resolution: 0.050V/D (Volt/Duty Cycle)

Output (0.00V ～ 10.00V) Resolution: 0.100V/D (Volt/Duty Cycle)

Calculate the measured duty cycle formula: (output voltage (V)/resolution) = duty cycle (%).

For example: output (0.00V ~ 5.00V) output is 2.5V

       (2.5(V)/0.05) = 50(%).