4X O2 Oxygen Sensor for Holden Commodore VE SV6 Omega 3.6L 2006 2007 2008-2011

 

Description：

Oxygen sensors help to optimise fuel economy, reduce harmful emissions and improve engine performance.

 

Fitment:

For Holden Commodore VE SV6 Omega 60th Anniversary International  Lumina 3.6L 2006-2011

 

 

Specification:

Condition: 100% Brand New

Type: Oxygen Sensor 

Terminal Type: Pre-cat

Premium Quality Replacement Part

Warranty: 3Years

 

Package:

2x Front O2 Oxygen Sensor

 

2x Rear O2 Oxygen Sensor

 

 

Note:

Professional installation is recommended! 

Please double check the vehicle’s original part number before purchasing this part.

If you are not sure if this is the correct part, please contact us with the vehicle’s 17 digit VIN. In most cases, we can usually determine which part is the correct one for your vehicle by performing a VIN search.

 

 

Where are my oxygen sensors located?

 

 

Diagnostic Trouble Codes (DTC)

When oxygen sensor failure occurs, a DTC is recorded in the Engine Control Unit (ECU) and a Malfunction Indicator Lamp (MIL) is illuminated on the dash, alerting the driver the vehicle has a problem.

 

How to replace an oxygen sensor?

 

1- Disconnect the battery.

2- Locate the sensor connector by following its wires. Disconnect it.?

3- Remove the sensor cable from its clips all along its way to the sensor.

4- A specific 22mm socket with side cut out exists (see below). You can use a spanner instead. Hold it in one hand and give it a firm hit with the other hand. It will then unscrew very easily.

5- Remove the sensor and fit the new one.

6- Re-route the cable carefully and meticulously and fix it at every clip. Reconnect the connector.

7- Reconnect the battery and wait 5 minutes before starting the engine.