This plan is for a Class A Profile Jumpin Bean U-Control model airplane.

The model can be powered with any .15 or 19 displacement engine and flown on 40 to 52 foot lines.

 The plan is an enlargement of a .049 plan. It was re-drawn on 11 x 17” plates so it is necessary to section the fuselage view. It is however very easy to match the drawing of the two sections.

This was done to avoid the cost of a full sized fuselage pattern printing. The savings is well worth the cost. Plans with a 30” wing or more are very expensive.

Steel cable .012 or .015 U-Control lines are recommended. If you do not have or can not find wire this small then .020 is acceptable.

The fuselage is cut from 1/2 or 3/8" balsa forming a profile or silhouette of the plane. You may need some 1/16 and 1/8 ply depending on how your engine mounts.

 The wing is built up with ribs cut from 1/16 or 3/32 sheet balsa. 

 Sheet balsa wings work very well if you use the KFM airfoil system. Information on the KFM wing can be found on the internet by searching “ KFM Family of Airfoils” This airfoil works great with U-Control models. They build simple, fast, straight, and strong.

 The tail assembly can be made from 1/8 or 3/16 sheet balsa.

 You really should have some scratch building experience as the plans contain only material dimensions and no material or parts are included.

 The origin of these plans vary from re-drawing’s from the internet or from my private collection.

 ONCE AGAIN .. THE LISTING IS FOR PLANS ONLY SO LOOK AT THE PICTURE CLOSLEY. I DO NOT ACCEPT RETURNS FOR OBVIOUS REASONS. PLANS ARE MAILED FOLDED AND IN ALMOST ALL CASES WITH USPS TRACKING AND MAILED OUT WITHIN TWO BUSINESS DAYS.