| OE Manufacturer: | BOSCH |
| Product Type: | Starter |
| Weight: | 9.2500 |
| Condition: | NEW |
| Unit Source: | |
| Design / Type: | |
| Design / Type: | PMGR |
| Design / Type: | |
| Starter Series: | PG260G |
| Location - General: | |
| Location - Specific: | |
| Design Type: | |
| Voltage: | 12 |
| Amperage: | |
| kW: | 1.5 |
| Rotation: | CW |
| Regulator/Fan: | |
| Tooth Count: | 11 |
| Spline Count: | |
| Polarity: | |
| Shaft Type: | |
| Duty Cycle: | |
| Horsepower: | |
| RPM: | |
| V-Set: | |
| Circuit Type: | |
| Plug Code: | |
| Plug Orientation: | |
| Pulley Class: | |
| Case OD (mm): | |
| Overall Length (mm): | 237 |
| Gear OD (mm): | |
| Pulley Belt Width (mm): | |
| Pulley OD (mm): | |
| Shaft Overall Length (mm): | |
| Shaft OD (mm): | |
| Clutch Type: | |
| Operating Mode: | |
| Pads Included: | |
| Connection Type: | |
| Piston Material: | |
| Number of Pistons: | |
| Piston Outside Diameter (in): | |
| Piston Outside Diameter (mm): | |
| Bleeder Port Measurement: | |
| Inlet Port Measurement: | |
| Ignition Type: | |
| Housing Material: | |
| Torque (ft. lbs): | |
| Pulley OD (in): | |
| Crankshaft OD (in): | |
| Terminal Type: | |
| Sensor Included: | |
| Idle ACM Included: | |
| Cage Wheel Included: | |
| Wiring Harness Included: | |
| Number of Pistons: | |
| Caliper Pistion OD (mm): | |
| Motor Overall Length (in): | |
| Motor OD (in): | |
| Wheel OD (in): | |
| Bearing Inside Diameter (mm): | |
| Bearing Outside Diameter (mm): | |
| Bearing Width (mm): | |
| Rotor Inside Diameter (mm): | |
| Rotor Outside Diameter (mm): | |
| Rotor Overall Length (mm): | |
| Rotor Shaft Outside Diameter (mm): | |
| Rotor Shaft Overall Length (mm): | |
| Mounting Hardware Included: | No |
| Installation Hardware Included: | |
| Mounting Type: | |
| Mounting Type: | Pad |
| Mounting Type: | |
| Cap Design: | |
| Plunger Type: | |
| Includes: | |
| Includes: | |
| Number of Mounting Holes: | 2 |
| Number of Terminals: | |
| Number of Wires: | |
| ETB Inside Diameter (in): | |
| Terminal Type: | |
| Hose Inside Diameter: | |
| Minimum Flow Rate: | |
| Minimum Pressure: | |
| Compressor Type: | |
| Control Valve Included: | |
| Refrigerant Type: | |
| Oiling Type: | |
| Number of Pulley Grooves: | |
| Discharge Port (mm): | |
| Suction Port (mm): | |
| Oil Quantity (oz): | |
| Anti-Lock Brake Sensor Included: | |
| Wheel Hub Inside Diameter (mm): | |
| Wheel Hub Outside Diameter (mm): | |
| Pre-Greased: | |
| Number of Wheel Studs: | |
| Unit Finish: | |
| Unit Color: | |
| Number of Pieces: | 1 |
| Country of Origin: | CN |
| Country of Use: | |
| Notes: | |
| Other Part #: | 10465579, 19136238, 9000854, 9000906 |
Customer Service Available 7 Days A Week
Cadillac Escalade 2002-2002 V8 5.3L 5328cc 325cid
Chevrolet Avalanche 1500 2002-2002 V8 5.3L 5328cc 325cid Optional Unit; PG260F2
Chevrolet Avalanche 1500 2002-2002 V8 5.3L 5328cc 325cid Standard Unit; PG260G
Chevrolet Express 1500 2003-2003 V8 5.3L 5328cc 325cid VIN T
Chevrolet Express 2500 2003-2003 V8 4.8L 294cid
Chevrolet Express 2500 2003-2003 V8 5.3L 5328cc 325cid
Chevrolet Express 3500 2003-2003 V8 4.8L 294cid
Chevrolet Silverado 1500 2002-2002 V8 4.8L 294cid VIN V Standard Unit; ID 12563908
Chevrolet Silverado 1500 2001-2001 V8 4.8L 294cid VIN V
Chevrolet Silverado 1500 2002-2002 V8 5.3L 5328cc 325cid VIN T
Chevrolet Silverado 1500 2002-2002 V8 5.3L 5328cc 325cid VIN Z
Chevrolet Silverado 1500 2001-2001 V8 5.3L 5328cc 325cid
Chevrolet Suburban 1500 2001-2002 V8 5.3L 5328cc 325cid
Chevrolet Tahoe 2001-2002 V8 4.8L 294cid
Chevrolet Tahoe 2001-2002 V8 5.3L 5328cc 325cid
Chevrolet Trailblazer EXT 2003-2003 V8 5.3L 5328cc 325cid
GMC Envoy XL 2003-2003 V8 5.3L 5328cc 325cid
GMC Savana 1500 2003-2003 V8 5.3L 5328cc 325cid
GMC Savana 2500 2003-2003 V8 4.8L 294cid
GMC Savana 2500 2003-2003 V8 5.3L 5328cc 325cid
GMC Savana 3500 2003-2003 V8 4.8L 294cid
GMC Sierra 1500 2002-2002 V8 4.8L 294cid Standard Unit; ID 12563908
GMC Sierra 1500 2001-2001 V8 4.8L 294cid
GMC Sierra 1500 2002-2002 V8 5.3L 5328cc 325cid VIN T Delco PG260F2
GMC Sierra 1500 2002-2002 V8 5.3L 5328cc 325cid VIN T Delco PG260G
GMC Sierra 1500 2002-2002 V8 5.3L 5328cc 325cid VIN Z Delco PG260F2
GMC Sierra 1500 2001-2001 V8 5.3L 5328cc 325cid
GMC Yukon 2001-2002 V8 4.8L 294cid
GMC Yukon 2001-2002 V8 5.3L 5328cc 325cid
GMC Yukon XL 1500 2001-2002 V8 5.3L 5328cc 325cid
Isuzu Ascender 2003-2003 V8 5.3L 5328cc 325cid
*NOTE: "M.T" Indicates Manual Transmission / "A.T" Indicates Automatic Transmission*
Please Reach Out To Customer Service To Confirm Fitment, If Necessary.
Please note the overall length of this unit is 237mm, with 11 teeth, and the power rating is 1.5kW.
Because this unit is a Gear Reduction, it may not have the same tooth count as the unit you are replacing.
If you are replacing a 6494 (1.1kW, 9 tooth) unit with this 6489 (1.5kW, 11 tooth) unit, please be sure that you have enough installation space.
This 6489 unit is approximately 22cm longer than a 6494 unit.
WE STRIVE TO PROVIDE A 5 STAR EXPERIENCE!

Our objective is 100% customer satisfaction. If we did not fulfill your expectations please contact us using eBay messager.
All of our products are covered by a one year warranty from the date of purchase.
We offer warranty for products that have a manufacturing defect due to materials or workmanship. The warranty does not cover failure due to abuse, misuse, improper installation or modifications. We are not liable for the cost of installation, removal or any other expenses beyond the original purchase price of the item.
It is the responsibility of the customer to verify the correct application information prior to purchasing any product from our eBay store. All purchases made in error may be returned within 30 days from the date of purchase and are subject to a 20% restocking fee. The product must be returned in its original condition including the packaging.
Free shipping on purchases shipped to all 50 states.
We offer international shipping through eBay global shipping program.
We process and ship orders within one business day of the order information being received. With the exemption of U. S. holidays.
Expedited orders including next day, second day and third day delivery methods are processed and shipped the same business day if checkout is completed by 5pm Eastern Time.
We reserve the right to change shipping carrier and shipping method for efficient and on-time deliveries. OEG Parts is not responsible for carrier delays such as weather or natural disasters.
All returns must be approved with a Return Material Authorization Number (RMA #) that must be included with the return
To receive an RMA Please contact OEG Parts Customer Service.
All returned products will be inspected. Returns processing may take up to 3 business days from the time your product is received at our return facility locations.
Immediate payment is required during checkout. We will process and ship orders once checkout is completed.
Often, Customers reach out to us to help confirm fitment of parts prior to purchase.
We always recommend cross referencing a part number to ensure fitment as well.
You may Contact Us by locating the "Contact Seller" Button within a listing.
After making a purchase, the phone number will be visible to you through eBay when you click on "Contact Seller".
You can also find our phone number by clicking on FAQs > Other
It is against eBay Policy to provide you our contact information any other way.
categories