• CV Axles Replacement 
  •  
  • BEFORE YOU INSTALL
  •  
    • Lift vehicle using suitable equipment and safety precautions before installing replacement CV Drive Axle.
    • Check condition of engine and transmission mounts for damage before installing replacement CV Drive axle. 
    • Check condition of suspension and steering components before installing replacement CV Drive axle. 
    • Correct or repair any pre-existing suspension damage or chassis sub frame alignment issues before installing the replacement CV Drive Axle.If the drive train has shifted to one side, the axle might pull out while turning, resulting in catastrophic axle failure. 
     

    • Pair New Rear CV Axles for Honda Rincon 680 2006-2022 Left & Right

    CV Axles Replacement 

     

    BEFORE YOU INSTALL

     

    • Lift vehicle using suitable equipment and safety precautions before installing replacement CV Drive Axle.
    • Check condition of engine and transmission mounts for damage before installing replacement CV Drive axle. 
    • Check condition of suspension and steering components before installing replacement CV Drive axle. 
    • Correct or repair any pre-existing suspension damage or chassis sub frame alignment issues before installing the replacement CV Drive Axle.If the drive train has shifted to one side, the axle might pull out while turning, resulting in catastrophic axle failure. 

     

    ​TIPS

     

    • Compare the original and replacement units. Ensure the splines and overall compressed length match the original.
    • Make every effort to prevent debris from contacting operating surfaces or entering bearings. Protect seal surfaces during CV Drive Axle installation.
    • Be sure to replace any damaged fasteners with components of equal or better quality.
    • Be sure to use, as applicable, OE approved fluids, lubricants, adhesives or sealants as specified by the vehicle service manual.
    • If both CV Drive Axles are being replaced, complete the removal and installation on one side before removing the second side. This is very important on some applications such as Fords. Removing both CV Drive Axles may cause the differential gears to become dislocated, requiring disassembly of the transaxle for reassembling of gears.
    • Never over-extend or over-angle a CV Drive Axle joint, as this will cause damage. Keep outer end supported while servicing the inner end of the assembly.
    • Vehicle splines and installation surfaces must be clean. Lubricate CV splines to assist installation. Apply a thin film of grease to CV oil seal contact surfaces.
    • Before operating the vehicle, check transmission lubricant level, refill with correct lubricant as needed.

    Item Specifics
    Brand X-engineclub
    Manufacturer Part Number XE1799184220G
    Fitment Type Direct Replacement
    Features Lubricated Joints;Puncture-Resistant Boots
    Compatible Make For Honda
    Type Axle Parts
    Modified Item No
    Material Steel
    Warranty 2 Years
    Universal Fitment No
    Surface Finish Painted
    Quantity 2pcs
    OE Spec or Performance/Custom OE Spec
    Color Black
    Attachment Type Bolt-On
    Compatible Type ATV & SxS UTV
    Items Included CV Axle Assembly
    Placement on Vehicle Rear Left Right

    Payment

    1.Payment by eBay approved method.

    2.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)

    3.Payment must be received within 10 days as auction ended or order might be delayed.

    Shipping

    1. Orders processed within 24 hours of payment verification.

    2. The images shown are not the actual item and are for your reference only.

    3. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!

    Returns

    1. You have 30 days to contact us and 10 days to return it from the date it was received. 

    2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.

    3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement.

    Contact Us

    You may contact us via message if you have any questions and we will reply to you within 24 hours from Monday to Saturday.(Excluding local holidays)

    Shop Category
     Store Home
     Turbocharger
     Ignition Coil
     Spoilers
     Body kits
     Window Motors & Regulators
     Axle Housings & Parts
     Electric Motor
     Window Mouldings
     Rocker Panels
     Complete Strut
     Struts & Suspension Kit
     Brake Calipers
     CV Axle
     throttle body
     Shocks & Struts
     Headlight Assembly
     fuel injector
     Other
    Hot Item
    New List Item
    Help & Info
    Payment Policy
    Shipping Policy
    Return Policy
    FAQ
    About Us
    default
    10
    Pair New Rear CV Axles for Honda Rincon 680 2006-2022 Left & Right

    CV Axles Replacement 

     

    BEFORE YOU INSTALL

     

    • Lift vehicle using suitable equipment and safety precautions before installing replacement CV Drive Axle.
    • Check condition of engine and transmission mounts for damage before installing replacement CV Drive axle. 
    • Check condition of suspension and steering components before installing replacement CV Drive axle. 
    • Correct or repair any pre-existing suspension damage or chassis sub frame alignment issues before installing the replacement CV Drive Axle.If the drive train has shifted to one side, the axle might pull out while turning, resulting in catastrophic axle failure. 

     

    ​TIPS

     

    • Compare the original and replacement units. Ensure the splines and overall compressed length match the original.
    • Make every effort to prevent debris from contacting operating surfaces or entering bearings. Protect seal surfaces during CV Drive Axle installation.
    • Be sure to replace any damaged fasteners with components of equal or better quality.
    • Be sure to use, as applicable, OE approved fluids, lubricants, adhesives or sealants as specified by the vehicle service manual.
    • If both CV Drive Axles are being replaced, complete the removal and installation on one side before removing the second side. This is very important on some applications such as Fords. Removing both CV Drive Axles may cause the differential gears to become dislocated, requiring disassembly of the transaxle for reassembling of gears.
    • Never over-extend or over-angle a CV Drive Axle joint, as this will cause damage. Keep outer end supported while servicing the inner end of the assembly.
    • Vehicle splines and installation surfaces must be clean. Lubricate CV splines to assist installation. Apply a thin film of grease to CV oil seal contact surfaces.
    • Before operating the vehicle, check transmission lubricant level, refill with correct lubricant as needed.
    Item Specifics
    Brand X-engineclub
    Manufacturer Part Number XE1799184220G
    Fitment Type Direct Replacement
    Features Lubricated Joints;Puncture-Resistant Boots
    Compatible Make For Honda
    Type Axle Parts
    Modified Item No
    Material Steel
    Warranty 2 Years
    Universal Fitment No
    Surface Finish Painted
    Quantity 2pcs
    OE Spec or Performance/Custom OE Spec
    Color Black
    Attachment Type Bolt-On
    Compatible Type ATV & SxS UTV
    Items Included CV Axle Assembly
    Placement on Vehicle Rear Left Right


    1.Payment by eBay approved method.

    2.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)

    3.Payment must be received within 10 days as auction ended or order might be delayed.

    1. Orders processed within 24 hours of payment verification.

    2. The images shown are not the actual item and are for your reference only.

    3. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!

    1. You have 30 days to contact us and 10 days to return it from the date it was received. 

    2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.

    3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement.

    You may contact us via message if you have any questions and we will reply to you within 24 hours from Monday to Saturday.(Excluding local holidays)


    All rights reserved.