ANCEL DP500 Supports Key Programming Functions:

Programming & Erase Keys
All Key Lost Programming
Programming Remote
Pincode Reading
Key Numbers Reading
EEPROM Chip Reading
Reset ECM
Remote Matching

ANCEL DP500 Professional Mileage Adjustment Tool:

Read Odometer
Write Odometer
Read Flash
Write Flash
Read Eeprom
Write Eeprom

ANCEL DP500 Support 11 Special Functions:

✅Oil Reset Service
The lightening of the car maintenance light indicates that the vehicle needs maintenance.Reset the mileage or driving time to zero after the maintenance,so the maintenance light will go out and the system will start a new maintenance cycle.
✅ABS Bleeding
When the ABS contain air,the ABS bleeding function must be performed to bleed the brake system to restore ABS brake sensitivity.If the ABS computer,ABS pump,brake master cylinder,brake cylinder,brake line,or brake fluid is replaced,the ABS bleeding function must be performed.
✅Gear Learning
✅CVT Reset
✅Battery Match
This function enables you to perform a resetting operation on the monitoring unit of vehicle battery,in which the original low battery fault information will be cleared and battery matching will be done.
✅EPB Adaption
✅TPS Adaption
✅Steering Angle Reset
To reset the steering angle,first find the relative zero point position for the car to drive in straight line.Taking this position as reference,the ECU can calculate the accurate angle for left and right steering.After replacing the steering angle position sensor ,replacing steering mechanical parts(such as steering gearbox,steering column,end tie rod,steering knuckle),performing four-wheel alignment,or recovering car body,you must reset the steering angle.
✅DPF Regeneration
DPF Regeneration is used to clear PM(Particulate Matter)from the DPF filter through continuous combustion oxidation mode(such us high temperature heating conbustion,fuel additive or catalyst reduce PM ignition conbustion)to stabilize the filter perfornance.
✅Injector Coding
Writing injector actual code or rewrite code in the ECU to the injector code of the corresponding cylinder so as to more accurately control or correct cylinder injection quantity.After the ECU or injector is replaced,injector code of each cylinder must be confirmed or re-coded so that cylinder can better indentify injectors to accurately control fuel injection.
✅Suspension Matching
This function can adjust the height of the body.When replacing the body height sensor in the air suspension system,or coontrol module or when the vehicle level is incorrect,you need to perform this function to adjust the body height sensor for level calibration.

ANCEL DP500 Key Programming Tool Mileage Adjustment Tool Supports 8 Languages:

English/Spanish/French/Polish/Portuguese/Italian/German/Russian

Noted:

The default language of the device is English, if you want to update it to another language, please provide us with the product serial number

ANCEL DP500 Key Programming Tool Supported Model:

Fit For BMW, Fit For PORSCHE, Fit For BENZ, Fit For HONDA/ACURA, Fit For CITROEN/PEUGEOT, Fit For BYD, Fit For GREATWALL, Fit For VW/SEAT/SKODA/AUDI, Fit For FIAT, Fit For TOYOTA, Fit For FORD, Fit For JAGUAR, Fit For GEELY, Fit For CHRYSLER/DODGE/JEEP, Fit For RENAULT, Fit For DACIA, Fit For SUZUKIT , Fit For LANDROVER, Fit For MAZDA, Fit For LUXGEN, Fit For OPEL, Fit For CHERY, Fit For KIA, Fit For NISSAN/INFINITI, Fit For ROEWE, Fit For MITSUBISHI, Fit For SSANGYONG, Fit For SUBARU, Fit For SMART, Fit For GM, Fit For ISUZU, Fit For HYUNDAI, Fit For IVECO, Fit For ZOTYE, Fit For VOLVO, Fit For DAEWOO

Key Programming Highlights:

-Compatible With Ford EXPLORER/EXPLORER SPORT/TRANSIT CUSTOM/RANGER/FUSION etc supports up to 2019
-Compatible With Renault CLIO/CAPTURE/DUSTER/KOLEOS etc supports up to 2015
-Compatible With GM EQUINOX/MALIBU/TERRAIN supports to 2020
-Compatible With GM CASCADA /ENCLAVE/REGAL/ESCALADE/CAMARO/IMPALA etc supports up to 2019
-Compatible With Hyundai ACCENT/ELANTRA SEDAN/G90/GENESIS/KONA/SONATA etc supports up to 2019
-Compatible With Landrover DISCOVERY 4/RANGE ROVER/RANGE ROVER EVOQUE supports up to 2015
-Compatible With Volvo S60/V40/XC60 supports to 2017
-Compatible With MAZDA MAZDA 6/MAZDA CX-3/MAZDA CX-5 etc supports up to 2018

ANCEL DP500 Odometer Correction Tool Supported Model:

Compatible With VWH, SKODA, AUDI, SEAT, PORSCHE, BENZ, FORD, CHRYSLER, GM, HYUNDAI, INFINITE, KIA, MAZDA,, MITSUBISHI, NISSAN, SSANGYONG, SUBARU, SUZUKI. FIAT, CITROEN, LANDROVER, JAGUAR, RENAULT, PROTON, PEUGEOT, OPEL, VOLVO, SMART, TOYOTA/LEXUS, ALFA, IVECO

Mileage Correction Highlights:

-Compatible With Chrysler 300C/PACIFICA/CHALLENGER/CHARGER/DURANGO/RAM etc supports up to 2018
-Compatible With Ford F250/F350/F450/F550/FIGO/ASPIRE/KA supports up to 2018
-Compatible With Renault CAPTUR/CLIO/TRAFIC IV supports up to 2017
-Compatible With GM TRAILBLAZER supports up to 2019
-Compatible With GM ESCALADE / XTS / COLORADO supports up to 2018
-Compatible With part of ALFA/Porsche mileage correction

Even thougt the tool is compatible with the car brands above, different function will be a little bit difference with the car compatibility.
Please offer your car brand+model+release year to seller. We will check if it's compatible with your car.

ANCEL DP500 Supports One Key Upgrade Via WiFi:

Built-in WIFI mode can realize application, downloading and diagnostic function by one key upgrade.

ANCEL DP500 Supports Remote Assistance:

This application can realize remote hosting operation via the third party's software: Quick Support

ANCEL DP500 Product Parameters:

Operation System: Android 5.1.1
CPU: RK3128 Quad-core, ARM Cortex A7@1.2Ghz
Battery: 3800mA, rechargeable polymer lithium battery
Extension Memory Card: 32G Micro SD (TF) card supported
Storage Capacity: 16GB
LCD：7 inch
LCD Resolution: 800*480
Touch Screen: capacitive touch screen
Wifi: supported
Working Temperature: -20℃～55℃（14℉～131℉）
Storage Temperature: -20℃～70℃（-4℉～158℉）
Weight: 850g
Dimension: 214*133*28mm
Package Size: 388*120*298mm
Package Weight: 3.0kg