★ Dental Flexible Denture Machine Is a 400w/110v Dental Laboratory Equipment for Making Flexible Removable Partial Dentures. .

★ the Denture Produced by the Invisible Denture Injection Molding Machine Has Almost No Waste Edge, and the Grinding Process Can Be Completed at One Time.

★the Denture Injection System Is Easy to Operate, Has a Long Service Life, Low Maintenance Cost, High Success Rate, and Dental Laboratory Equipment for Denture Injection System, Which Is Very Necessary for Dentists.

★ This Machine Is Produced According to International Standards. the Operation Is Simple, Time-saving, the Casting Success Rate Is High, and the Common Tooth Box Can Also Be Injection Molded.

★ the Denture Injection Unit Consists of a Heater and a Hot Press. Heaters: Temperature Control, Timers and Electrical Systems. Hot Presses: Frames, Cylinders, Heaters, Brackets and Flasks.

Features: Voltage: Ac 110v/60hz Power: 400 Watts Heating Temperature: 282-288 ° C Pressurization Time: 7 Minutes 30 Seconds - 11 Minutes Packing Size: 40*34*57cm Gross Weight: 30kg   The Package Includes: 1x Heater 1x Hot Press 1x Picking Stick 1x Small Top bar 1x Big Top bar 1x Type Box 1x Box Wrench 1x Power Cord 1xproduct Brochure

Steps:

1 the Function of the Heater Is to Heat the Ink Cartridge at a Temperature of 282-288 ° C for About 7 Minutes 30 Seconds - 11 Minutes to Melt the Flexible Denture Material in the Ink Cartridge.

2 the Function of the Hot Press Is to Inject Molten Material into a Previously Prepared Flask.

3 the Heater Will Beep When It Is Heated.

Note

Please Read the Product Manual Carefully Before Operating the Machine.