NOTE:

The Tire Pressure Sensor is 100% new and come pre-programmed specifically for your make/model/year of vehicle,need activate them by scal tool or "re-learning".

Installation of TPMS is recommended to be performed only by trained professionals.

This original equipment General Motors TPMS replacement set of (4) sensors arrives as pictured and will fit on any Dodge vehicle that requires a 433 MHZ from 2007-2020. This sensor is OEM quality and has been Manufactured for AcDelco for an exact fit on your GM vehicle.



Replace Part Number:

56029398AB, 68241067AB,
56029398AA, 68142397AA, 68241067AB, 68406537AA




Package Include:
 
 
4 x TPMS(Tire Pressure Monitoring Sensor)



Vehicles Fitment:

            Chrysler; 300; 2012-2016; W/Rubber Stem Snap-in Sensor

Chrysler; 300; 2011

Chrysler; Town & Country Van; 2016-2011

Dodge; Challenger; 2016-2010; W/Rubber Stem Snap-in Sensor

Dodge; Charger; 2012-2016

Dodge; Charger; 2011-2010; W/Rubber Stem Snap-in Sensor

Dodge; Durango; 2015-2011

Dodge; Grand Caravan; 2016-2011

Dodge; Journey; 2016-2011

Dodge; Ram 4500HD; 2012-2013

Dodge; Ram 5500HD; 2012-2013

Dodge; Ram Series Pickup; 2012-2013

Dodge; Ram Series Pickup; 2011-2010; W/Rubber Stem Snap-in Sensor

Fiat; 500; 2016-2012

Jeep; Grand Cherokee; 2016-2011

Jeep; Wrangler; 2013/01-2021/06 (433 MHZ only)

Mitsubishi; Lancer; 2013-2011; W/Alloy Wheels

Mitsubishi; Outlander; 2013-2011; W/Alloy Wheels



NOTE: Please check part number carefuylly to make sure it fits your model. 



Installation Process

1. Loosen the tire: Remove the valve cap and core and deflate the tire.
2. Dismount the tire: Clamp the tire onto the tire changer, and adjust the valve at 1 o’clock relative to the tire separation head. Insert the tire tool and lift the tire bead onto the mounting head to discount the head.
3. Dismount the sensor: With a screwdriver remove the fastening screw and sensor from the Valve stem, then loosen the nut and remove the valve.
4. Mount sensor and valve: Slide the valve stem through the valve hole of the rim. Tighten the screw-nut with 4.0 Nm with the help of the positioning pin. Assemble the sensor body against the rim and tighten the screw.
5. Mount the tire: Place the tire on the rim, making sure that the valve faces the separation head at an angle of 180 degrees. Mount the tire over the rim.