Upgrade your IKEA SKÅDIS setup with these heavy-duty mounting brackets. Designed for fast installation, a clean finish, and reliable long-term hold. Includes all the screws, plugs and caps you need.
Perfect alignment – slot-indexed brackets lock into SKÅDIS positions for an accurate fit.
20 mm stand-off – keeps hook clearance and allows cables to pass behind the board.
Includes screws + wall plugs – 5×60 mm screws, 6 mm plugs, washers & matching caps.
Fast one-person installation – “pivot + dimple” method makes marking holes easy.
Clean look – low-profile caps hide screws for a tidy finish.
Tested under real load – see results below.
2-Pack — Bottom Security
Replaces the two lower SKÅDIS clips for a stronger base.
4-Pack — Full Replacement (Most Popular)
Replace all four factory clips for maximum rigidity.
6-Pack — Extra Hold
Adds two additional mid-edge fixing points for weak walls or heavier setups.
10 kg static load for 72 hours on a 560×560 SKÅDIS mounted to 18 mm OSB using 5×60 mm screws — no movement.
Recommended working loads (solid substrates):
• 4-pack → up to ~8 kg
• 6-pack → up to ~10–12 kg
(Actual performance depends on wall type and anchors. For plasterboard/stud walls, use rated anchors or mount directly into studs.)
Each bracket includes: 20 mm spacer, 5×60 mm screw, 6 mm wall plug, washer, and cap.
2-Pack → 2× of each item
4-Pack → 4× of each
6-Pack → 6× of each
White, Black, Grey
Strong, high-quality 3D-printed polymer (PLA)
Zinc-plated steel screws + solid wall plugs
Designed & tested in the UK.
Fit the first bracket loosely so the board can pivot.
Rotate board, use screw tips to create position dimples.
Drill 6 mm holes for solid walls. Insert plugs flush.
Fit screws with washers and hand-tighten.
Tighten the first bracket and press caps on.
Done.
For plasterboard/stud walls: use appropriate rated anchors (not included unless specified).
Fits all IKEA SKÅDIS pegboards
20 mm spacing works with hooks, shelves, holders, and cable-routing setups