1. 1 The most important step is to clean the surface where
the sticker will go on, so it is free from wax, grease or other car products.
For plastic, you can use a mild detergent. Omitting this step will result in the
non-union of the sticker to the surface.
2. 2 Peel the back side plastic covering away,
exposing the sticky part of the signature. A tip to separate the 2 pieces of
plastic apart is to peel them away at a sharp angle.
3. 3 Stick the signature along with the top
protective plastic onto the surface firmly, run over the signature with your
fingernail or with a plastic credit card to ensure the signature is firmly glued
to the surface.
4. 4 Peel away the top layer, similar to step 2, and remove
carefully at a sharp angle whilst retaining the actual signature in place