New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. See all condition definitionsopens in a new window or tab
Brand
Unbranded
Temperature
160°C ~ 480°C
Voltage
220V
Corded/Cordless
Corded
Model
SS-331H
MPN
Does Not Apply
Features
ESD-Safe, Fine Tip, Stand Included, LCD
Item Type
Desoldering Gun
Vacuum Pressure
>600mm Hg
Country/Region of Manufacture
China
Power
140W
UPC
Does not apply
Item description from the seller
SS-331H Digital LCD Desoldering Station Electric Desoldering Gun Tin Sucker 220V（The item does not support 110V） Description： SS-331H LCD desoldering station is efficient desoldering tool with a built-in vacuum for through-hole boards and components. It is a thermostatically controlled desoldering station that provides low cost and high performance. Ergonomically friendly structure allows one hand operation, only takes a few seconds per pin, more safe, efficient and comfortable.
Features：
- High power desoldering tool with vacuum - Efficient operation, quick and easy - Microprocessor Controlled, provides accurate temperature control from 160 to 480°C - Ceramic heater, provides fast heat up, fast recovery and high insulation resistance - Designed with a quality heating element, it provides higher performance and longer lifetime than traditional type
- Built-in high power 600mmHg air pump, particularly for lead-free desoldering of multilayer boards - Large LCD display - Quick and easy to set the desired temperature and check the actual temperature. - Fahrenheit or Celsius unit selection.
Specification Type: Electric Desoldering Gun Model:SS-331H Voltage:220V 50Hz （NOT support 110V） Soldering Power:90W Power Consumption:140W Temperature:160°C ~ 480°C Vacuum Pressure:>600mm Hg Heating Element:Ceramic Heater Size: 172*135*190mm Weight: 2.0kg
SS-331H Correct Use
1.After each work, it is recommended to suction 3-5 times and empty the residual tin in the tube;
2.If the interval between use is about 20 minutes, it is recommended to clean the steel pipe with a needle after air suction;
3.It is found that the suction is reduced during use, please clean the steel pipe with a needle;
4.If the frequency of use is very low, it is recommended to adjust the tin gun to about 200 degrees, and then to the working temperature when using;
5.When the tin slag in the tin storage cylinder is about 1/2, it should be cleaned in time. When the filter cotton is found to be hardened, it needs to be replaced in time.
What's in the package:
1x Electric Desoldering Gun 3x Nozzles 4x Filter sponges 3x Needles 1x User manual