NTC Thermistor To Voltage 100K NTC To 0-5V 0-10V Linear Conversion Temperature Transmitter Module

Introduction

NTC 100K resistance-to-voltage module: This is a linear conversion module, which converts the input ntc resistance signal into temperature (voltage signal) output through internal chip processing.

There are two output voltage range options.

 

Module parameters

1. Working voltage: 9V ~ 24V

2. Input resistance: NTC 100K thermal resistance (B value: 3950)

3. Output voltage: 0.00V ～ 5.00V/0.00V ～ 10.00V

4. Temperature measurement range: -20～+150 (degrees).

5. Output mode: S2 pad on the circuit board: open circuit (output 0.00V ~ 5.00V); short circuit (output 0.00V ~ 10.00V), the default is open circuit.

6. Application scope: remote data acquisition and control equipment;

7. Size: (length) 26mm * (width) 23mm * (height) 10mm

8. Module interface:

24V: Power supply positive port (9V ~ 24V).

G: Power ground interface.

IN: The positive interface of the thermal resistance.

G: The negative terminal of the thermal resistance.

OUT: Signal output interface (0.00V ~ 5.00V/0.00V ~ 10.00V).

G: Power ground interface.

Note: When the output is 0.00V ~ 10.00V, the power supply voltage must be 15V.

Output (0.00V ～ 5.00V) Resolution: 0.0294117V/℃ (Volt/Celsius)

Output (0.00V ～ 10.00V) Resolution: 0.0588235V/℃ (Volt/Celsius)

Calculate the measured temperature formula: (output voltage (V)/resolution)-20℃ = measured temperature (℃).

Package

1pc NTC thermistor to voltage 100K NTC to 0-5V 0-10V linear conversion temperature transmitter module