| USB Extender Plus T/R |
|---|
| USB host support | xHCI (USB 3.0), EHCI (USB 2.0), OHCI/UHCI (USB 1.1) |
| USB data rates | Low speed (1.5 Mbps), full speed (12 Mbps), high speed (480 Mbps) |
| USB host — Tx units | |
| Number/signal type | 1 USB |
| Connectors | 1 female USB type B |
| Maximum built-in USB hubs | 2 |
| Minimum built-in USB hubs | 0 |
| Optional built-in USB hubs | Peripheral emulation enabled: 1
1:n network pairing enabled: 1 |
| USB device ports — Receiver | |
| Number/signal type | (1) 4-port, USB hub |
| Connectors | 4 female USB 2.0 type A |
| Maximum built-in USB hubs | 1 |
| Minimum built-in USB hubs | 1 |
| Available USB power | 500 mA per port |
| Interconnection between transmitter and receiver | |
| NOTE | This product supports the four types of data transfer defined by USB: bulk, control, interrupt, and isochronous transfers. |
|
| Connectors | 1 female RJ-45 per unit |
| Termination standards | TIA 568B |
| Signal transmission distance | |
| Point to point | Up to 330' (100 m) |
| Over the network | Up to 1980' (600 m)** |
| NOTE | **Over the network distance is through connection of up to five network switches. |
|
| NOTE | The transmission distance varies depending on the type of cable used in the system. |
|
| Network | |
| Protocol | Ethernet |
| Transport | TCP/IP, UDP |
| All supported | IPv4, UDP, DHCP, Unicast |
| Standards | IEEE 802.3u (100Base-T), IEEE 802.3ab (1000Base-T) |
| IP Configuration | Static IP (default) or DHCP |
