PLEASE READ BEFORE PURCHASE

This OBD cable will only work if your vehicle’s OBD port supplies power to the socket.

For Parking Mode, your OBD port must provide constant power even when the ignition is OFF.

Many vehicles only power the OBD port when the ignition is ON. If your OBD port does not supply power in the way you require, Parking Mode will NOT function with this cable.

Please check your vehicle’s OBD behaviour before buying.
Please check the following before purchasing:

1) This cable uses an OBD connector — ensure your vehicle has an OBD II port.
2) Fits only the BlackVue models listed below.
3) Item is supplied New – Posting Without Retail Box.

Product Description

The CONECTA Dash Cam Power & Parking Cable is the quickest and simplest way to power your BlackVue dash cam directly from your vehicle’s electrical system — without visible wires and without the time‑consuming task of hardwiring into the fusebox.

This OBD cable enables both Normal Driving Mode and Parking Mode, allowing your BlackVue dash cam to continue recording after the ignition is switched off (vehicle‑dependent — see warning above).

Installation is simple: plug the cable into your vehicle’s OBD II port, connect the other end to your BlackVue dash cam, then tuck the cable neatly around the dashboard and headlining for a clean, discreet setup.

The cable includes built‑in battery discharge protection, ensuring your dash cam cannot drain your vehicle’s battery.

Key Features

Compatibility

Compatible with the following BlackVue dash cam models:

⚠ Important Vehicle & Camera Compatibility Note

Some vehicles do not output an ACC (ignition) signal through the OBD port. This can affect how certain BlackVue cameras behave when powered via OBD.

✔ Fully Compatible BlackVue Models (S-Series & Earlier)
DR900S, DR750S, DR590W, DR590, DR650S, DR490, DR470, DR450, DR430
These models will:
• Power on normally
• Enter Parking Mode automatically when the ignition is off
• Record while the vehicle is parked (Parking Mode enabled)

❌ Not Compatible With X-Series Models
DR750X, DR900X, DR770X, DR970X
These newer X-Series cameras require a true ACC signal to switch between Normal Mode and Parking Mode.
If your vehicle’s OBD port does not provide ACC (common on some Ford, BMW, Mercedes, Audi, VW, hybrids and EVs), the camera may:
• Only operate in Parking Mode
• Appear “off” if Parking Mode is disabled in the app
• Not power on at all without ACC

This behaviour is normal for the X-Series and is not a cable fault. Please check your camera model and vehicle before purchase.

Condition

New – Posting Without Retail Box

Dispatch & Postage

• Fast dispatch via Royal Mail tracked service
• Secure, protective packaging used for every order
• Professional business seller