eBay

Master Tailgaters Replacement for Ford Fiesta Hatchback, Fiesta ST (2018-2019) Backup Camera OE Part # D2BZ-19G490-E

Replaces Model Number: D2BZ-19G490-E (D2BZ19G490E)

For use with:

Ford Fiesta Hatchback (2018-2019)
Ford Fiesta ST (2018-2019)

This is an aftermarket backup camera, not OEM. This camera will plug into your existing wire harness. If your vehicle currently does NOT have a backup camera system, this camera will not work. Double Check your part number prior to ordering.

STEP ONE: CALL
Before ordering this item:
First, you need to call the Parts Department of your local dealer to find out your exact Part Number.

STEP TWO: CHECK
Double check your Part Number with our part number to confirm.

Oftentimes, people buy the wrong camera because they only match the model/year of their car.
To avoid this, you just need to compare your part number to this one and make sure they match!

STEP THREE: PURCHASE
Once you complete steps ONE and TWO, and confirmed a match, you can purchase this camera without having to worry about whether or not it will work for your vehicle!

Camera Specs:

Sensor: ¼” On-Semi (USA) CMOS Active Pixel Array, Lens: Nidec (Japan) (Glass + Plastic)
Minimum Illumination : .1 Lux light sensitivity
Signal System : NTSC/PAL
Effective Pixel : 728 x 582
Electronic Shutter : 1/50 to 1/100,000 seconds
Resolution : 600 TV lines
Angle : 170 Degrees
Waterproof Rate : IP68
Power : DC 6v-12v

OE CAMERAS BACKED BY A 1 YEAR WARRANTY!!!

**ATTENTION: Before purchasing, make sure to call your local dealer to verify that your part number is an EXACT MATCH to this part number*
[For use with]: Ford Fiesta Hatchback (2018 2019), Ford Fiesta ST (2018 2019) OE Part # D2BZ-19G490-E (D2BZ19G490E)
[Camera]: Wide angles up to 168°(Diagonal) + 100°(Vertical) + 136°(Horizontal); Designed for low light to .1lux
[Specs] Up to 800TVL; Waterproof to IP69K; Safe working temp from -104F to 220F. Japanese Nidec Lens, OnSemi USA Chip
[Plug and Play]: Plugs into Existing OEM Video Harness, no programming required