THIS FOR FOR THE ITEMS PICTURED AND DOES NOT, REPEAT-DOES NOT INCLUDE ANY REFRIGERANT.

THIS FOR FOR THE ITEMS PICTURED AND DOES NOT, REPEAT-DOES NOT INCLUDE ANY REFRIGERANT.

THIS FOR FOR THE ITEMS PICTURED AND DOES NOT, REPEAT-DOES NOT INCLUDE ANY REFRIGERANT.

J.B. Industries

Part# M2-460

Made for the 30 and 15 pound refrigerant jugs.

This one is for the jugs 

This is a very special gauge set up that will screw onto, by hand, to the 30 lb. or 15 lb. jugs of refrigerant cans that have the 1/4" male flare fitting and allow you to direct charge the system you are working on. 

You don't even have to take the jug out of the box anymore!

NOTE: Almost "ALL" of these size cans have the 1/4" male flare fitting, the only can that does not is the automotive jugs of R134a that say "automotive ", Those jugs have the 1/2" ACME fitting which is a little larger then the 1/4". We do have adapters for those cans if you need one.

This particular gauge is set-up for the following flavors;

If you shut the tank valve off it will show you the system pressure.

You don't need to take your whole gauge set on the roof now just throw this in your pocket and you good to go.

We also make them for and The Envirosafe products.

It comes with a nice screw-in plug to keep it clean and a cap & strap for the hose connection to keep that fitting clean as well.

We have the same set-up with different hose lengths as well.

The last 3 pictures showing the gauge hook-up to the refrigerant can.

Please note, the sticker and the refrigerant can is NOT included in the , this is for the gauge set-up only!

Please visit our eBay store and click on the can taper category.

Thank you!