Hydraulic Hose Assembly: 1/4 in x 1/4 in Fitting Size, MNPT x MNPT, 3/8 in Hose Inside Dia., Black

Hose Inside Dia.
3/8 in
Hose Outside Dia.
11/16 in
Hose Length
5 ft
Hose Tube Material
Synthetic Rubber
Hose Cover Material
Synthetic Rubber
Hose Reinforcement Material
Carbon Steel
Hose Color
Black
Max. Working Pressure @ 70 F
4,800 psi
Safety Factor
4:1
Temp. Range
-40° to 212°F
Standards
SAE J517C 100R2
Hose Configuration
Coupled Assembly
Hose Fitting A Size
1/4 in
Hose Fitting B Size
1/4 in
Hose Fitting A Material
Carbon Steel
Hose Fitting B Material
Carbon Steel
Hose Fitting A Type
MNPT
Hose Fitting B Type
MNPT
Compatible Chemicals
Air; Automatic Transmission Fluid; Diesel Fuel; Ethylene Glycol; Fresh Water; Fuel Oil; Gasoline; Hydraulic Fluid (Petroleum); Hydraulic Fluid (Synthetic); Kerosene; Lithium Grease; Lubricated Air; Mineral Oil; Motor Oil; Salt Water
Not Recommended Chemicals
0; Acetic Acid (Glacial); Acetic Acid 20%; Acetic Acid 80%; Acetone; Chromic Acid 10%; Chromic Acid 30%; Chromic Acid 5%; Chromic Acid 50%; Citric Acid 50%; Formic Acid; Hydrochloric/Muriatic Acid (100%); Hydrochloric/Muriatic Acid (20%); Hydrofluoric Acid (20%); Hydrofluoric Acid (75%); Hydrofluoric Acid 100%; Methyl Ethyl Ketone (MEK); Nitric Acid (10% Solution); Nitric Acid (20% Solution); Nitric Acid (50% Solution); Nitric Acid (Concentrated Solution); Phosphoric Acid (40% Solution); Sulfuric Acid (10% - 75%); Sulfuric Acid (75% - 100%); Sulfuric Acid (to 10%)
Brand
EATON AEROQUIP
UNSPSC
40142005
Country of Origin
USA (subject to change)
Product Description

These Eaton Aeroquip FC579 hydraulic hose assemblies are suitable for high-pressure applications and have crimped-on rubber strain relief on their ends that helps extend the hoses' life. They have an abrasion-resistant SBR (styrene-butadiene rubber) tube and cover and are reinforced with two layers of steel wire braids for strength. The hose exhibits low volumetric expansion under pressure, which helps maintain the efficiency of the hydraulic system. These hydraulic hose assemblies are used for hydraulic jacking applications with petroleum- and water-based fluids. They come with fittings installed on both ends and are ready to connect to compatible equipment.