This is a very special gauge set up that will screw onto, by hand, any 30 lb. or 15 lb. jugs of refrigerant cans that have the 1/4" male flare fitting and allow you to direct charge the system you are working on. 

 

 (1) Long Neck Gauge Assemble.

(1) 36" Blue Charging hose with the 1/4" fitting on the hose ends.

(2) adapters with caps and straps.

(1) Low-Side Snap-On Coupler

 

The charging hose end does have a valve core depressor and can be used on all systems that have the 1/4" male flare fitting with or without the valve core. 

 

You don't even have to take the jug out of the box anymore!

 

NOTE: Almost "ALL" of these size cans have the 1/4" male flare fitting, the only can that does not is the automotive jugs of that say automotive ac coolant.

 Those jugs have the 1/2" ACME fitting which is a little larger then the 1/4". We do have adapters for those cans if you need one.

This particular gauge is set-up for the following 

Includes:

Screw-on Gauge assemble

36" hose

 low-side automotive coupler

2 tank adapters

all item as pictured however does not include the sticker.

If you shut the tank valve off it will show you the system pressure.

You don't need to take your whole gauge set on the roof now just throw this in your pocket and you good to go.

It comes with a nice screw-in plug to keep it clean and a cap & strap for the hose connection to keep that fitting clean as well.

We have the same set-up with different hose lengths as well.

Please note, the ac coolant is NOT included in the !

Please visit our eBay store and click on the can taper category.

The sticker in the picture are not included and are for reference only!

Thank you!