BRAND NEW
**Double Layer ADT Logo**
Replacement Vinyl Sticker
for ADT Yellow or Stainless Steel Boxes
Please read this short note before you buy any label !!
If you decide to buy then please read the fitting instructions below before application
There are many ADT vinyl stickers being sold on eBay. While all of them will rejuvenate the look of your bell box, many sellers are using a much lesser quality label. We would like you to consider these few things before you buy any.
1. Check whether you are buying a "SINGLE" layer or "DOUBLE" layer sticker
A SINGLE layer sticker is produced with a single white vinyl background with a blue "printed" logo on top. These will have a much shorter life span as the printed "ink" will fade much much quicker - less than 3 years.
A DOUBLE layer sticker is produced with two individual SOLID colour vinyl sheets. A white background and a blue stenciled top layer. These DO NOT use "printed inks" and our supplied has stated can last up to 10 years.
2. Check the vinyl quality
If the label, paper, vinyl or adhesive is not good quality, it will peel off much quicker.
We only use Avery Dennison as it is one of the best but it is more expensive to produce.
3. Check out the sellers other items
Check if your seller is just an "opportunist" selling ONLY labels which were produced by a local printer
Our items are related to alarms and these labels are produced by a commercial printer to the highest quality.
OUR LABELS !!!
Our labels are DOUBLE LAYER vinyl sheets produced using
AVERY DENNISON top quality adhesive paper. They can be used to rejuvenate your old, faded, scratched or logo damaged bell box cover and last a long time without fading or peeling
You can also use them on bell box covers that have no logo at all
They are made by a professional graphics company who produce 1000's vinyl graphics for the commercial and trade
Designed to last up to 10 years !!
**free 1st class postage**
Sun damage (over the years) is the primary cause
for fading of the original ADT screen printed logo
Get these replacement vinyl stickers to
make you old logo STAND OUT again
Please see my photos
1.Before and After fitment
2. Fitment Process
These stickers come in two parts
1. The WHITE backing sticker
2. The ADT Logo - this is a blue "ADT" cut out
NOTE: Before Fitting
Please make sure the surface of the alarm box is dust free, clean and dry for the vinyl to adhere properly !!
(You do not need to use a hair dryer)
Fitting instructions:
White Vinyl Label
- The surface of the decoy must be clean and dry and free from dirt
- Remove the backing film from the white label
- Align the White label and "roll flat onto the decoy smoothing out any bubbles
- Remove the protective top film from the white label
Blue Vinyl Label
- Firmly press down over the blue "ADT" logo from the front of the label
- Slowly and carefully remove the backing film from one corner and ensure that the logo does not come away with the backing paper - the ADT logo should now be in "reverse" on the front protective film
- Align the Blue label and "roll flat onto the White label smoothing out any bubbles
- Remove the protective top film from the ADT label
- Cut out the screw hole
Sticker Measurements
Backing sticker - 152mm x 115mm
Logo Sticker - 152mm x 115mm
(They are made slightly bigger than the original logo
to make sure you don't see the original after fitment)
Quantity Per Order
2 x White Backing Stickers
2 x Blue ADT Logo Stickers