Yamaha Blaster Aftermarket Oil Pump cover.

Made from U.S.A. 6061 Aluminum.

Comes with U.S.A. S.S. bolts.

Comes packaged as shown. Off the mill "raw". You will need to polish it if you do not like the "raw" finish or give it a "brushed" look with a brillo pad.

You MUST use an oil block off kit as the factory oil line grommets were deleted from this design.

You MUST use RTV of your choice or a case bond, gasket maker, ect to seal the cover.

You MUST use antisieze on the S.S. hardware so it does not seize from reaction to the aluminum clutch cover.

These were designed to match the "lower deck" of the clutch cover for a more sleek look.