What's the AC contactor?

1. The AC contactor is an automatic controller that uses electromagnetic suction to make and disconnect the circuit. It is mainly composed of an iron core, a coil, and a contact. The AC contactor controls the start and stop of the compressor.

2. Fault phenomenon: the press does not start and does not work

3. Detection method:

1. Detect the resistance of the coil winding to see if it is disconnected or short-circuited;
2. Use the ohm gear of the multimeter to detect the on-off status of the upper and lower contacts of the AC contactor. 
The resistance value of the upper and lower contacts should be infinite when the power is not turned on. If there is a resistance value, it indicates that the internal contacts are stuck;
3. Press the forced button on the surface of the AC contactor, and use a multimeter to measure the resistance of the upper and lower contacts. 
The resistance of each group should be zero under normal circumstances. 

If it is infinite or the resistance increases, it indicates that the internal contact surface may have Arc phenomenon. 
If the above three phenomena occur, the AC contactor should be replaced;

4. Notes:
For single-phase 3-horse air conditioners, the AC contactor is easily damaged when the voltage is unstable or the voltage drop during startup is large. 
will cause the above failures.

MPN:CJX9B/25SD CJX9B/25S

1Pole : CJX9B/25S
2Pole : CJX9B/25SD

CJX9B-25S/D AC contactors are generally used to control the single-phase loaded circuit systems, which are of AC 50/60Hz, rated coil voltage up to AC 220-240V and rated  thermal current up to 32A. 

They are extensively applied to control the main circuit of single-phase mechanical devices and the compressors of single-phase air conditioners.

Please confirm from the specifications in the listing that if this item will be compatible with your device before you placing order.

If you have any inquiries or questions please don't hesitate to contact us before purchasing,Thank you!

Package Included:

1x AC Contactor

----( Random Batch / Color / Type Will Be Sent Out As Default )