OEM RAPA Porsche Panamera 970 valve block air suspension

UK SHIPPING & IMPORT TAXES

This part is shipped directly from our Germany warehouse to you. Because of that, all parts are subject to an Import Tax. This Import Tax can vary depending on the part type and declared value, and the percentage depends on the part type. Please be advised that the Import Tax is not included in the purchase price of this part, and the Buyer is responsible for this cost once they received the part.

Description

This control unit (valve) 97035815325, 97035815303 of the air suspension of the Porsche Panamera 970 comes from the same production line of the original manufacturer RAPA.

Miessler Automotive is the only company where you can get this Made in Germany air suspension valve with the same OEM quality and specifications.
If you are unwilling to compromise on quality and reliability, then Miessler Automotive Germany is the only aftermarket source for high-quality and reliable air suspension valves.
Info:
DRIVING SAFETY, DAMPING FORCE, FUEL CONSUMPTION
Pneumatic and hydraulic valves are used at key points in the chassis to ensure smooth operation.
Therefore, the integration of mechatronic systems such as air suspensions, controlled damping, roll stabilization and other active chassis systems is playing an increasingly important role in development.

We would be happy to provide you with a quote for diagnosis and installation (repair) in our own automotive workshop.
Please contact us by clicking on the "Question about the product" button.

Can be installed in the following vehicles:
Porsche Panamera 970 (G1) 2009-2016

Replaces the valve with the following part numbers:
97035815304, 97035815303, 97035815302
97035815326, 97035815325, 97035815324, 97035815323, 97035815322
Continental OES:
15.1524-0027.2, 15152400272
15.1524-0028.2, 15152400282
15.1524-0026.2, 15152400262

Scope of delivery:
Original OEM RAPA valve

Important NOTE:
Before using your old pressure hose, cut off 5mm with the hose cutter.
Use only the new connector that is already on the replacement part.
Insert the pressure hose firmly until it stops.
Only in this way can a perfect seal be guaranteed.

Danger!!!
The vehicle suspension is based on a combination of electronically controlled level control and air springs filled with nitrogen 5 or CO2.
The pressure in the system MUST be 17 bar as the starting pressure after replacing any spare parts, such as compressor, air spring, valve and/or strut.
A compressor can only partially compensate for the pressure difference.
In principle, the relevant installation instructions of the car manufacturer MUST be followed.
Should you fail to follow these instructions and your system continues to display an error;
Or should a replacement part purchased by us be damaged for this reason,
Therefore, this is neither covered by warranty nor guarantee.
Completely emptying the system is the general requirement of the car manufacturer.
After replacing the relevant spare part, the system MUST be refilled with CO2 or nitrogen 5 according to the vehicle manufacturer's specifications.
This can only be done with appropriate software and special tools.
Only then can you start further steps, such as calibration or commissioning of the level control.

Your advantages:
- Made in Germany
- Much more cost-effective than a contracted repair shop
- Personal consultation
- As a German provider, we are subject to the European right of withdrawal.
- 2-year warranty
- Worldwide express shipping is standard with us
- We have the longest experience in Europe with the topic of air suspension for automobiles in the aftermarket.

---