Mercedes E 211 compressor air suspension AIRMATIC

Description

This compressor A2113200304 for the Mercedes E-Class (W211, S211) is characterized by the highest quality standard (quality management) and additional scope of delivery.

The included suspension elements for the compressor prevent increased vibration noise.

We would be happy to make you an offer for diagnosis and installation (repair) in our own vehicle workshop.
Please contact us by clicking on the button: “Question about the product”.

Can be installed in the following vehicles:
Mercedes-Benz E-Class (W211) 2002-2009
Mercedes-Benz E-Class (S211) 2003-2009
Mercedes Benz E-Class AMG (W211) Sedan 2002-2009
Mercedes Benz E-Class AMG (S211) station wagon T-model 2002-2009
Mercedes Benz E-Class 4Matic (W211) Sedan 2002-2009
Mercedes Benz E-Class 4Matic (S211) station wagon T-model 2002-2009

Replaces compressors with the original spare part numbers:
A2113200304, 2113200304, 211-320-03-04
A2113200104, 2113200104, 211-320-01-04
A2193200004, 2193200004, 219-320-00-04

Scope of delivery:
compressor
relay
Set of fastening parts

Warranty only if a new relay is used!

Before purchasing a compressor, please consider the following:
The most common reason for a faulty compressor is a leak in the system, causing the compressor to run for too long.
This then leads to a burnout of the device.
A leak can occur in many places, such as:
- Porous or damaged air springs or air spring components (suspension strut)
- Worn seals, defective compressed air connections and chafed compressed air hoses
- Leaky housings in components such as compressors, valves, air springs or suspension struts.

The compressor warranty cannot be guaranteed if a leak persists.

Your advantages:
- Assembly and quality assurance by Miessler Automotive® Germany
- Much cheaper than an authorized workshop
- Personal advice
- As a German provider, we have the European right of withdrawal
- 2 year guarantee
- Worldwide express shipping is standard for us
- We have the longest experience in Europe with air suspension for automobiles in the aftermarket.

Our technical advice for air supply:
1. An increased running noise of the compressor is often caused by the suspension of the compressor no longer functioning.
Be sure to also change the suspension rubbers and springs.
2. A porous intake hose is often the cause of compressor failure.
Change this and, ideally, the filter/noise damper at the same time.
We don't want the new compressor to fail prematurely for this reason.
3. Change the working relay before installing the compressor, even if it still appears to be functional.
This is also a mandatory requirement of the car manufacturer.
Make sure you are changing the correct relay. Relays are similar. There is a great risk of replacing the wrong relay.
4. After the repair, make sure that the system is absolutely tight.
The easiest way to determine this is to park the vehicle and wait for the system to automatically adjust (if your vehicle has this feature). Accurately measure and note all heights that are air-assisted, from the ground to the bottom edge of the fender. The next day check and compare these heights.
Even a small deviation in the distances leads to long-term damage to the compressor and the valves.

If you have been driving for some time with a leaky undercarriage, it can be assumed that the compressor is running more often than normal. This increased number of on and off cycles may have already damaged the compressor. Depending on how long this condition has lasted, you should change the relay as a precaution and check the compressor's performance. After the car has been parked overnight, a compressor should not run for more than 20 to 30 seconds until the system is ready to start again.

---