Mikuni Oz Product Description
Please note:
This kit comes pre jetted for the 865cc and is a set of twin carburetors only. If you require the 760cc kit it is listed separately.
This Mikuni RS40 carburetor Kit will breathe a whole new lease of life into your Triumph America, Bonneville, Scrambler 900, Speedmaster and Thruxton 900 twins with an up to 25% increase in power, whilst making it perform and operate as it should with no hesitations or flat spots.
You will very quickly realize that the expense of a rebuild of your old worn OEM carbs can far exceed the cost of these new units and unfortunately as with many rebuilds now days you only have the option in many cases of gambling with very poor quality aftermarket parts. Considering this and if intending to ride and enjoy your motorcycle for years to come, it makes good sense to retire your OEM carbs into the cupboard and step up to a set of RS’s, the improvement will be very impressive.
Before rushing in and ordering please firstly check your carb spacing and carbie sizes for compatibility.
This Mikuni kit comes with a 133mm carb throat centre to centre spacing between carb 1 & 2 for direct fitment to Triumph 790cc and 865cc twin models and at a 100mm back to front total length will adapt to the stock air-box (55mm dia.) , engine inlet rubbers (42mm) and throttle cables.
These carbs are supplied with jetting to suit your Triumph and will rarely need further tuning other than with the supplied two spare sets of mains for WOT testing for confirming correct tune. Simply bolt them on and hold on. The fitment of a performance clutch and spring kit is often required to keep up with the new found power. Removal of the sensor on the earlier models has no effect on performance or operation.
Your stock throttle cables will on most models connect to these carbs (note in the picture how the OEM cables must be laid over to the center and then pass up over the RH side of the rocker box), where we also have available in the RS accessories page either our road bike throttle and cable assembly (KRS-001) or a Quick action 1/4 turn throttle and cable kit (PPQA40K)
You can also buy separately either POD filters or Velocity stacks for racing, which have no form of filter in them (15, 30,50 and 75mm long).
Additional
Information:
Please Note: Other than exact replacement OEM
carburetors, all Mikuni Aftermarket Carburetors and Tuning Components are sold
“As Is” for Off Road / Racing Use Only and are not intended or approved for use
on vehicles operated on Public Roads or in locations where applicable engine
tampering and anti-pollution laws apply.
All shipping within Australia is via Australia Post
only.
Please note that we are located at Townsville North
QLD and that all standard shipping “Free Freight” travels by train from us all
the way down the East Coast as far as Victoria. EBay freight times are
estimates only and do not take in to account our location. We have express
options available for all our products also. The freight times around Australia
are as follows-
Standard or
eBay “Free Freight”
Townsville to Brisbane 3 days, Townsville to
North/Just South and West is usually 1-2 days,
NSW ACT & VIC 4-6 days, TAS & SA 4-8 days, WA
& NT 8-12 days.
Express Freight
Anywhere in QLD except some rural areas is next day
delivery. NSW ACT & VIC 2 days, TAS & SA 2-3 days, WA & NT 3-4
days.
Please note that weather events such as flooding,
cyclones and other natural disasters etc will delay any ground freight. This is
entirely out of our control if this occurs.
All international shipping is done through Australia Post
Express Courier EMS service.
The international service we use is generally 4-5 Business
days for delivery but can be shorter or longer.
Our business
Warranty or Return period is 7 days only. We do accept eBay’s 30 day return
policy but please read all the information below carefully before making your
purchase.
THE
FOLLOWING INFORMATION IS FINAL.
Here at Mikuni OZ we do offer refunds and returns but
there are strict procedures for this.
All carburetor kits that need to be returned for
refund or exchange MUST be returned in the exact same way they left the
warehouse. All Carburetors & Carby kits that have been opened WILL BE
thoroughly stripped and inspected, in the case of any fuel being added, greases
or lubricants, tampering or any form of damage to the carburetor there will be ABSOLUTELY
NO refund and the kit will be returned to you at your expense! THIS IS FINAL
AND NO OTHER EXCEPTIONS!
Absolutely all returns for any reason will be charged
a 10% restocking fee whether it has been opened or not before it was returned
and the freight for us to send you the kit originally will be deducted also
before your refund is issued.