PRE CUT CLEAR BRA PAINT PROTECTION FILM FOR: Cadillac Escalade (2021-2022)

See compatibility list

PRE CUT KIT COVERAGE:  Half Hood, Front Bumper, Head Lights, Fog Lights & Mirrors

 

Factory Crafts uses ORAGUARD 270 Stone Guard Film it is Medium-term paint protection for automotive fenders, rear bumpers

and deck or side skirts, and other outdoor applications. Use on flat and slightly curved surfaces. Digitally cut with the latest

PPF data software for the perfect fit. PPF needs to be stretched for installation so you may see it short if just laying it out on car.

• Protects Paint Against Wear and Tear from Deterioration, Chips and Scratches.
• German made High Quality ORAFOL Brand.
• ORAGUARD 270 Stone Guard Film is a 6 mil Clear Gloss PVC Laminate Paint Protection Film.
• SELF-HEALING PROTECTION: This 6-millimeter, clear-gloss PVC laminate paint protection film uses self-healing technology that repairs scratches using the heat of the sun. 
• The precut protective film will help create a professional-looking finish.
• Wet application is recommended when installing as a paint protection film, dry if used as a laminate.
• We highly recommend a professional Installer for best results.
• Oraguard 270 is great for flat to moderate curved surfaces.
• Each piece of the PPF kit is precisely cut to the EDGE of each part and is not a Wrap around.
• For proper fit it will require about a 10% tension stretching to the sides to conform to the body. (Cadillac Escalade 2021-2022)
• Our PPF kits are cut to order and may take up to 5 business days to ship out.

INSTALLATION INSTRUCTIONS

To achieve an optimum result, thoroughly clean the base before applying the ORAGUARD®- stone guard protective film.

Cleaning the base:

The vehicle base should generally be cleaned with conventional cleaning agents. Do not use substances attended to form a coating or sealing layer by means of nanotechnology on the base to be cleaned.

 

a) Clean the vehicle. 

b) Thoroughly check surfaces and edges for residues of preservative wax or polishing agents and remove them with industrial cleaning agents or silicone remover (isopropyl Alcohol alone is not effective).

c) Finally, the surfaces to be bonded must always be cleaned with isopropyl Alcohol. This will remove most efficiently all residues of previously used cleaning agents (spirit is not recommended).

d) Thoroughly dry the vehicle, use hot air blower to remove any residual moisture, particularly moisture trapped under rubber seals.

 

Note: Solvent residues due to improper cleaning or a recent paint job may result in blisters forming between the film and the base and affect adherence. Make sure that films are only bonded to completely dry and hardened coating finishes. As a rule of thumb, allow a minimum drying period of three weeks.