Swing Axle / Straight axle Hub oil throw back washer , made in stainless steel . Originals are usually beaten up and bent so no longer doing what they was intended for .

These fit inside the bearing housing between the casting and the hub seal , so any oil leaking past the seal will not enter the brake shoe area . Its the second barrier after the rubber hub seal .

For vehicles running the cast bearing housings .

2 x are needed per vehicle  , sale is for 1 washer .

Centre hole is 30mm in Diameter . (FOR USE ON VEHICLES USING THE 36MM HUB NUT . ) will not fit on late model reduction boxes as they use a 46mm hub nut , also they never used a washer .

In the diagrams it is part number 10 and 13 in the other image .