Connect Air Turbine To Mast - Just Buy a *1-1/4 pole from your local hardware store this bolts right on literally ALL YOU NEED don't pay 5-600$ for a mast kit buy 10 foot poles for about 15$ each and raise to desired height connect turbine with THIS adapter tighten INCLUDED HARDWARE( 5/16" bolts, washers and nuts.) to mast - THAT'S IT your done.
*This flange measures 13/4" inside measure even though it is a 1 1/4" flange. The set screw will take up some slack but be sure to test the pipe you want to use first, you may need 1 1/2" pole.
Can be used as a stationary floor flange but needs to be bolted or anchored into a concrete foundation or hard ground.
This base can also be used to mount your wind turbine to concrete or hardened ground. Just cut your post to length, set inside and use the set screw to mount in place. This floor flange is made of malleable galvanized cast steel and is rust-resistant. In my other listing , I sell a small pole adapter pipe that fits into the flange and will allow a pipe to screw on.
The flange must be secured using anchor bolts or stakes for hardened ground (not included). Likely will not be sturdy enough for a large/heavy wind turbine, but for a smaller style this can act as a base if carefully secured to concrete. This will ship via USPS.
Specifications: