MID PTO DUST COVER
Fits Kubota B2150 • B1550 • B1750
Keep grass off your mid PTO (power take-off) shaft and help protect the seal.
On the B2150, the mid PTO stub spins any time the rear PTO is running. Grass and chaff wrap around those bare splines, and that buildup can damage the seal. This bolt-on cover encloses the stub so grass has nothing to grab.
WHY YOU'LL LIKE IT
- Helps protect the seal: grass and chaff stay off the spinning splines.
- Bolt-on, no drilling: uses the factory bottom bolt hole.
- Stays put: the bolt plus 5 built-in magnets hold the cover firmly so it will not shift.
- Plenty of clearance: lots of room around the shaft. Test-fitted on a B2150.
- UV-resistant: 3D-printed ASA material.
- Fits either thread: comes with both a 5/16-18 and an M8 x 1.25 stainless steel bolt.
WHAT'S IN THE KIT
- Dust cover with 5 built-in magnets on the mounting face for extra holding force
- Two stainless steel bolts (5/16-18 and M8 x 1.25), so it fits either thread
- Stainless steel washer that spreads the load
FITS
Kubota B2150 (tested)
Kubota B1550 and B1750 (same mid PTO case)
EASY INSTALL
- Engine off, key out.
- Remove the bottom bolt.
- Set the cover over the stub.
- Use whichever bolt threads in by hand, with the washer, and snug it. Never force it or re-tap.
SIZE
Overall: 4.25 x 3 x 3.5 in
Inside depth: 2.5 in • Bore: 1.5 in
B2150 stub measured about 1 in diameter with 1.75 in protrusion
Shipping: Ships in 1-3 business days.
Returns: 30-day returns, buyer pays return shipping.
Fits Kubota models listed.
Fitment & safety: Dust cover only, not a safety shield. Install with engine off and key removed. Remove before using a mid-PTO implement. Verify fit on your model before use.
Not affiliated with or endorsed by Kubota.
IRONRUT