1:50 scale showman's 16 supercar 1950s-60s traditional dodgems kit
NOTE! this model does not come with printed instructions or yellow/red roof coveringyou can download the instructions pdf and free printable roof covering pdf from www.lobokit.co.ukThere is also a build aid photo pdf with photos to help building
This is an MDF laser cut model kit of a traditional oval Fairground dodgems trackwith 16 1950-60 supercar type dodgem cars 3d printed in high detail 
This kit is designed as a static modelIt is based on dodgems around the 1950s to 1960s I have supplied an optional front sign board, many tracks did not have this but some did 
The kit is supplied on laser cut MDF boards, the parts easily detach using a knife to cut the remaining holding tabsThe kit has been designed to give the look of the original with all the intricate roof and fencing woodworkThe arena has etched panels and buffers
If you wish to put the wire mesh electric contact panels on the underside of the roof, there is room for this but you will need so supply and build your own as this is not supplied.  
Assembly instruction manual pdf now available to view or download at lobokit.co.uk 
The red/yellow roof covering is not supplied with this but I have produced a free pdf document that is printable on 8 x A4 sheets of paper you can print and cut these out if you wish and use them on the model, the download link for these is at lobokit.co.uk

The 16 cars are 3D printed using High resolution resin, they are very detailed and quite a good finish comparedto standard 3d printingthey are supplied with the separate steering wheelsThese can be glued with superglue or epoxy etc
You would need to supply your own poles for the cars, these can be 1mm plastic rod or tube glued onor very thin piano wire with insulation stripped from a piece of wire slid over it.
This is a great addition to any layout and is a fantastic model when painted and your own lighting added etc
This kit is quite easy to build, there are a few fiddly bits but nothing majorthe Kit is assembled using wood glue or similar.

you will receive the MDF kit, a download link for roof tarp/ instructions etc, 16 x 3d printed cars with 16 separate steering wheels.

The overall size of the top is, 540mm wide x 296mm from front to backFrom floor to peak of roof is 98mm The base is approx. 499mm wide x 255mm from front to back

The cars are 35mm long x 23mm wide x around 15mm high plus top of steering wheel