Sci-Fi Mainframe Control Terminal — Diorama Prop for Action Figures
A proper command station, not a shelf-filler: nearly 10 inches wide at 1:12 scale, with a main display bank above, an operating desk across the middle, and two angled wing consoles canted in toward whoever is standing at it.
The detail is dense and deliberate. The desk carries a full keyboard, banked rotary dials, rocker switch strips and a raised central plinth. The upper bank frames a large blank main screen with recessed sub-displays either side, hex indicator clusters and cable runs. The wings repeat the idea at a smaller scale with their own keypads and readouts.
The desk sits at waist height on a figure of the matching scale — 2.58 in at 1:12 — so your figure stands at the controls instead of next to them.
The screens are deliberately blank. Paint them, decal them, or back them with foil or a small LED if you want them lit.
Features:
- A full command terminal, nearly 10 inches wide — main display bank, operating desk and two angled wing consoles, all one sculpt
- Choose your scale: 6" (1:12) or 4" (1:18) — select from the dropdown
- TOTAL ASSEMBLED SIZE — 6" scale: 9.77 × 4.50 × 8.00 in (248.1 × 114.3 × 203.2 mm). 4" scale: 6.51 × 3.00 × 5.33 in (165.4 × 76.2 × 135.5 mm). Measured from the model
- Prints as ONE piece — nothing to glue, no seams, no assembly
- The desk sits at waist height on a figure of the matching scale, so it poses standing at the controls rather than beside a prop
- Dense sculpted detail everywhere: a large blank main screen, full keyboard, banked rotary dials, rocker switches, hex indicator clusters and recessed sub-screens
- Two angled wing consoles with their own keypads and displays, canted in toward the operator
- Blank screens by design — paint them any colour, or back them with foil or an LED for a lit look
- Ships unpainted in gray PLA — the first photo shows a painted example; no figures are included
- 3D printed to order on our in-house production printers — display-ready as printed, or prime and paint for gunmetal casing, lit panels and worn edges
CHOOSE YOUR SCALE — select from the dropdown above:
- 1:12 Scale for 6 inch — 9.77 in wide, 8.00 in tall, 4.50 in deep (248.1 × 114.3 × 203.2 mm).
- 1:18 Scale For 4 inch — 6.51 in wide, 5.33 in tall, 3.00 in deep (165.4 × 76.2 × 135.5 mm).
How it's made:
3D printed to order in quality gray PLA on our in-house production printers, as one solid piece — no glue, no seams, no assembly. The neutral gray displays well straight off the printer,