Fitment:

1, You can distinguish specific model of an automobile by VIN(Vehicle Identification Number).

2, VIN(Vehicle Identification Number) consists of total 17 English letters and arabic digits.

3, VIN does not include the letters I (i), O (o), and Q (q) (to avoid confusion with numerals 1 and 0).

BMW 7 Series E65/E66/E67/E68 With EDC

745i Base Sedan 4-Door 4.4L 2002-2005
750i Base Sedan 4-Door 4.8L 2006-2008
750i Limited Edition Sedan 4-Door 4.8L 2008
750i Sport Limited Edition Sedan 4-Door 4.8L 2008
750i Sport Sedan 4-Door 4.8L 2006-2008
760i Base Sedan 4-Door 6.0L 2004-2006

745Li Base Sedan 4-Door 4.4L 2002-2005
750Li Base Sedan 4-Door 4.8L 2006-2008
750Li Limited Edition Sedan 4-Door 4.8L 2008
750Li Sport Limited Edition Sedan 4-Door 4.8L 2008
750Li Sport Sedan 4-Door 4.8L 2006-2008
760Li Base Sedan 4-Door 6.0L 2003-2008

Generation & Evolution:

BMW 7 Series

First generation (E23; 1977-1986)

Second generation (E32; 1986-1994)

Third generation (E38; 1994-2001)

Fourth generation (E65/E66/E67/E68; 2001-2008)

E65 Model Code: Sedan
E66 Model Code: Long Wheelbase

E67 Model Code: Armoured Car
E68 Model Code: Hydrogen-Powered

Fifth generation (F01/F02/F03/F04; 2008-2015)

F01 Model Code: Sedan
F02 Model Code: Long Wheelbase
F03 Model Code: Armoured Car Sedan
F04 Model Code: Hybrid Electric Sedan

Sixth generation (G11/G12; 2015-present)

Part Number:

37106778797,37126758579,
37126758581,37126767127,
37126785535,

37106778798,37126758580,
37126758582,37126767128,
37126785536

Removal & Installation:

1.Begin by removing the trunk floor and all cover panels.

2.Locate and remove the two (2) air conditioning ducts along the top edge of the trunk space.

3.Locate and remove the protective foam insulation covering the top of the strut tower.

4.Remove the three (3) top mounting nuts and disconnect the electrical plug. 

5.Set steering to straight ahead.
6.Raise vehicle.
7.Remove rear wheel.

8.Loosen and remove the sway bar end link nut from the bottom of the lower control arm and disconnect.

9.Remove the two sensor wires from the rear trailing arm bracket.

10.Loosen and remove the rear trailing arm’s ball joint nut and separate from the spindle assembly.

11.Loosen and remove the inner rear trailing arm nut and bolt.

12.Remove the rear trailing arm from the vehicle.

13.Loosen and remove the lower air strut mounting bolt.

14.Lower the air strut from its mounting location and remove the air line. Remove the air line fitting from the air hose and discard.

15.Remove the air strut from the vehicle.

16.Installation is in reverse order of air strut removal.

Package Includes:

2 X Rear Left And Right Air Suspension Struts