Description

  • The decoder has 1 output.
  • Motorola Operation can be done with DCC or Märklin Motorola.
  • The decoder is suitable for controlling Roco geoLine switches.
  • 100% quality testing of all decoders
    Development and production in Germany
    We only use components from well-known brand manufacturers


Compatible

  • decoder The decoder is the ideal alternative for the built-in digital decoder 61196.
  • Drives The decoder can be connected directly to the 61195 electric point drive.
  • Roco geoLine switches The decoder can be inserted and connected directly into the following switches.
    • Left switch 61140
    • Switch right 61141
    • Curved switch left 61154
    • Curved switch right 61155
    • Three-way switch 61160
    • Double crossing switch 61164


Tension

  • Build up
    • 9-24V track voltage
    The decoder is powered directly by the track voltage.
  • Performance
    • 9-24V DC voltage
    • 2A current
    The outputs can be loaded with 2A and supply 9-24V DC voltage.
  • Requirement
    • Quiescent current below 5mA
    The decoder itself requires less than 5mA when idle. The power requirement of the output depends on the connected item.
  • Short conclusion The decoders are protected against short circuits with a self-resetting fuse.


Coupl

  • Artificial intelligence At least a little. The decoder has an automatic learning mode for addressing. All you have to do is press a button and access the desired addresses at your headquarters. Complete.
  • Remote control The decoder can be configured directly at its location from a DCC control center using programming-on-main. All CVs can be updated.
  • inspection The decoder can be configured on a DCC programming track. All CVs can be read and written via direct mode.


configuration

  • standard By default the output takes small steps with a switching pulse of 400ms.
  • Twisted The switch output can be inverted. For example, switches in opposite directions can be switched with the same address.
  • Small steps You can adjust the switching pulse individually. Switching pulses from 10ms to 2,550ms are possible. And this in small steps of 10ms.


installation

  • Connections The decoder has all the connections for direct installation into a Roco geoLine switch.
  • Fastening The decoder can easily be attached to the inner bed of a Roco geoLine switch.
The decoder itself requires less than 5mA when idle. The power requirement of the output depends on the connected item. Artificial intelligence At least a little. The decoder has an automatic learning mode for addressing. All you have to do is press a button and access the desired addresses at your headquarters. Complete. Remote control The decoder can be configured directly at its location from a DCC control center using programming-on-main. All CVs can be updated. inspection The decoder can be configured on a DCC programming track. All CVs can be read and written via direct mode. Twisted The switch output can be inverted. For example, switches in opposite directions can be switched with the same address. Small steps You can adjust the switching pulse individually. Switching pulses from 1