Smoke In-Channel Wind Deflector, Rain Guard, Window Visor, Vent Deflector For BMW 3 SERIES F30 SEDAN 2012-2019

Package Included:

4Pcs / Set Wind Deflector

Fitment:

For BMW 3 SERIES F30 SEDAN 2012-2019

Specification:

Type: Wind Deflector, Rain Guard, Window Visor, Vent Deflector

Material: PC

Color: Smoked/Tinted

Product Type: In-Channel, Clip-On, Adhesive Double-Sided Tape

Features:

Rain Deflection: Keep your windows partially open during rain without getting soaked.

Wind Blockage: Reduce wind noise and turbulence inside the vehicle.

Sun Protection: Shield your eyes from the sun's glare, especially when driving low-angled sunlight.

Dust and Debris Prevention: Keep dust, dirt, and other debris from entering the vehicle.

Fresh Air Flow: Allow fresh air to circulate inside the vehicle without fully opening the windows.   

Reduced Heat: Help to cool down the interior of your car by allowing fresh air to enter.   

Fog Reduction: Prevent fogging on the windows by allowing air to circulate.

Installation Steps:

Materials Needed:

In-channel window deflector set

Cleaning cloth

Isopropyl alcohol ( We Don’t Provide)

Prepare the Vehicle:

Ensure the vehicle is parked on a flat surface with the engine turned off.

Clean the Window Channel:

Using a cleaning cloth, wipe the interior of the window channel to remove any dirt or debris.

Dampen a clean cloth with isopropyl alcohol and thoroughly clean the inside of the window channel. This will promote better adhesion.

Position the Deflector:

Identify the correct deflector for the specific window and side of the vehicle.

Gently place the deflector into the window channel, ensuring it is aligned correctly.

Insert the Deflector into the Channel:

Carefully insert the deflector into the window channel by following the contours.

Start from the front edge and slide the deflector into the channel, ensuring a secure fit.

Check for Proper Alignment:

Ensure the deflector is properly aligned within the window channel and sits flush against the glass.

Repeat for Other Windows:

Repeat the process for each window where deflectors are to be installed.

Operate Windows:

Gently roll up and down each window to ensure the deflector moves freely within the channel without any interference.

Allow for Setting Time:

It is advisable to allow the deflectors to set in the channels for a few hours before driving.

Note:

Do not forcefully slam the vehicle doors immediately after installation to avoid dislodging the deflectors.

Follow any additional recommendations or precautions provided by the manufacturer.

Maintenance:

Clean the deflectors with mild soapy water and a soft cloth.